LIS2DH12 datasheet(37/53 Pages) STMICROELECTRONICS

37 / 53 page

DocID025056 Rev 6

37/53

LIS2DH12

8.9

CTRL_REG4 (23h)

Table 37. CTRL_REG4 register

BDU

BLE(1)

1. The BLE function can be activated only in high-resolution mode

FS1

FS0

ST1

ST0

SIM

Table 38. CTRL_REG4 description

BDU

Block data update. Default value: 0

(0: continuous update;

1: output registers not updated until MSB and LSB have been read)

BLE

Big/Little Endian data selection. Default value: 0

(0: data LSb at lower address; 1: data MSb at lower address)

The BLE function can be activated only in high-resolution mode

FS[1:0]

Full-scale selection. Default value: 00

(00: ±2 g; 01: ±4 g; 10: ±8 g; 11: ±16 g)

Operating mode selection (refer to section 3.2.1: High-resolution, normal

mode, low-power mode)(1)

1. By design, when the device from high-resolution configuration (HR) is set to power-down mode (PD), it is

recommended to read register REFERENCE (26h) for a complete reset of the filtering block before

switching to normal/high-performance mode again for proper device functionality.

ST[1:0]

Self-test enable. Default value: 00

(00: self-test disabled; other: see Table 39)

SIM

SPI serial interface mode selection. Default value: 0

(0: 4-wire interface; 1: 3-wire interface).

Table 39. Self-test mode configuration

ST1

ST0

Self-test mode

Normal mode

Self test 0

Self test 1

11--

LIS2DH12 Datasheet(PDF) 37 Page - STMicroelectronics

LIS2DH12 Datasheet(HTML) 37 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53

Datasheet Download

Link URL