SPC560D30X datasheet(14/90 Pages) STMICROELECTRONICS

14 / 90 page

Package pinouts and signal descriptions

SPC560D30x, SPC56040Dx

14/90

Doc ID 16315 Rev 7

Figure 3 shows the Pictus 512K in the LQFP64 package.

Figure 3.

LQFP64 pin configuration (top view)

3.2

Pad configuration during reset phases

All pads have a fixed configuration under reset.

During the power-up phase, all pads are forced to tristate.

After power-up phase, all pads are forced to tristate with the following exceptions:

●

PA[9] (FAB) is pull-down. Without external strong pull-up the device starts fetching from

flash.

●

PA[8] (ABS[0]) is pull-up.

●

RESET pad is driven low. This is pull-up only after PHASE2 reset completion.

●

JTAG pads (TCK, TMS and TDI) are pull-up while TDO remains tristate.

●

Precise ADC pads (PB[7:4] and PD[11:0]) are left tristate (no output buffer available).

●

Main oscillator pads (EXTAL, XTAL) are tristate.

3.3

Voltage supply pins

Voltage supply pins are used to provide power to the device. Two dedicated pins are used

for 1.2 V regulator stabilization.

PB[3]

PC[9]

PA[2]

PA[1]

PA[0]

VSS_HV

VDD_HV

VSS_HV

RESET

VSS_LV

VDD_LV

VDD_BV

PC[10]

PB[0]

PB[1]

PC[6]

PA[11]

PA[10]

PA[9]

PA[8]

PA[7]

PA[3]

PB[15]

PB[14]

PB[13]

PB[12]

PB[11]

PB[7]

PB[6]

PB[5]

VDD_HV_ADC

VSS_HV_ADC

LQFP64

SPC560D30X Datasheet(PDF) 14 Page - STMicroelectronics

SPC560D30X Datasheet(HTML) 14 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90

Datasheet Download

Link URL