FT 5000 Tape and Reel Information

Devices are uniformly loaded in the carrier tape such that the device pin one is oriented

in quadrant 1 toward the side of the tape having round sprocket holes. Figure 15

illustrates the pin-one location.

User Direction of Feed

Figure 15: FT 5000 Pin One Orientation

Figure 16 shows the outline dimensions of the carrier tape.

Figure 16: Carrier Tape Outline Drawing

Ao = Bo = 7.25

Ko = 1.10

Notes

1. All dimensions are in millimeters.

2. Tolerances unless noted: 1PL + 0.2. 2PL + 0.1

3. 10 Sprocket hole pitch cumulative tolerance +0.2

4. Camber in compliance with EIA 481.

5. Pocket position relative to sprocket hole measured as true position of pocket, not pocket

hole.

For more information, refer to EIA-481-B, Taping of Surface Mount Components for

Automatic Placement.

Figure 17 shows the FT 5000 Series 13” Reel Drawing and Specification.

www.echelon.com

®

Recommendation: Add vias to the ends

of each pin pad connection (just outside

of the SMT pad rectangles) to provide

additional mechanical support for the

transformer.

FT-X3 Communications

Transformer Mechanical

Specification