HIP6006CBZ datasheet(4/12 Pages) RENESAS

4 / 12 page

HIP6006

FN4306 Rev.3.00

Page 4 of 12

April 1, 2005

Functional Pin Description

RT (Pin 1)

This pin provides oscillator switching frequency adjustment. By

placing a resistor (RT) from this pin to GND, the nominal

200kHz switching frequency is increased according to the

following equation:

Conversely, connecting a pull-up resistor (RT) from this pin to

VCC reduces the switching frequency according to the

following equation.:

OCSET (Pin 2)

Connect a resistor (ROCSET) from this pin to the drain of the

upper MOSFET. ROCSET, an internal 200A current source

(IOCS), and the upper MOSFET on-resistance (rDS(ON)) set

the converter over-current (OC) trip point according to the

following equation:

An over-current trip cycles the soft-start function.

SS (Pin 3)

Connect a capacitor from this pin to ground. This capacitor,

along with an internal 10

A current source, sets the soft-start

interval of the converter.

COMP (Pin 4) and FB (Pin 5)

COMP and FB are the available external pins of the error

amplifier. The FB pin is the inverting input of the error amplifier

and the COMP pin is the error amplifier output. These pins are

used to compensate the voltage-control feedback loop of the

converter.

EN (Pin 6)

This pin is the open-collector enable pin. Pull this pin below 1V

to disable the converter. In shutdown, the soft start pin is

discharged and the UGATE and LGATE pins are held low.

GND (Pin 7)

Signal ground for the IC. All voltage levels are measured with

respect to this pin.

PHASE (Pin 8)

Connect the PHASE pin to the upper MOSFET source. This

pin is used to monitor the voltage drop across the MOSFET for

over-current protection. This pin also provides the return path

for the upper gate drive.

UGATE (Pin 9)

Connect UGATE to the upper MOSFET gate. This pin provides

the gate drive for the upper MOSFET.

BOOT (Pin 10)

This pin provides bias voltage to the upper MOSFET driver. A

bootstrap circuit may be used to create a BOOT voltage

suitable to drive a standard N-Channel MOSFET.

PGND (Pin 11)

This is the power ground connection. Tie the lower MOSFET

source to this pin.

Typical Performance Curves

FIGURE 1. RT RESISTANCE vs FREQUENCY

FIGURE 2. BIAS SUPPLY CURRENT vs FREQUENCY

100

1000

SWITCHING FREQUENCY (kHz)

100

1000

RT PULLUP

TO +12V

RT PULLDOWN

TO VSS

100

200

300

400

500

600

700

800

900 1000

SWITCHING FREQUENCY (kHz)

CGATE = 1000pF

CGATE = 3300pF

CGATE = 10pF

OCSET

COMP

VCC

LGATE

PGND

BOOT

UGATE

PHASE

GND

PVCC

Fs 200kHz

510



RT k



---------------------



(RT to GND)

Fs 200kHz

410



RT k



---------------------

–



(RT to 12V)

IPEAK

IOCS ROCSET



rDS ON



--------------------------------------------

HIP6006CBZ Datasheet(PDF) 4 Page - Renesas Technology Corp

HIP6006CBZ Datasheet(HTML) 4 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

Datasheet Download

Link URL