| Electronic Components Datasheet Search |
|
M29W008EB Datasheet(PDF) 11 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
M29W008EB Datasheet(HTML) 11 Page - STMicroelectronics |
|
11 / 43 page ![]() M29W008ET, M29W008EB 2 Signal descriptions 11/43 2.6 Ready/Busy Output (RB) The Ready/Busy pin is an open-drain output that can be used to identify when the memory array can be read. Ready/Busy is high impedance during Read mode, Auto Select mode and Erase Suspend mode. After a Hardware Reset, Bus Read and Bus Write operations cannot begin until Ready/Busy becomes high impedance. See Table 13: Reset/Block Temporary Unprotect AC Characteristics and Figure 13: Reset/Block Temporary Unprotect AC Waveforms. During Program or Erase operations Ready/Busy is Low, VOL. Ready/Busy will remain Low during Read/Reset commands or Hardware Resets until the memory is ready to enter Read mode. 2.7 Reset/Block Temporary Unprotect Input (RP) The Reset/Block Temporary Unprotect input, RP, can be used to apply a Hardware Reset to the memory or to temporarily unprotect all blocks that have been previously protected. A Hardware Reset is achieved by holding RP Low, VIL for at least tPLPX. After Reset/Block Temporary Unprotect goes High, VIH, if the device is in Read or Standby mode, it will be ready for new operations tPHEL after the rising edge of RP. If the device is in Erase, Erase Suspend or Program mode, the Hardware Reset will last tPLYH during which the RB signal will be held at VIL. The end of the memory Hardware Reset will be indicated by the rising edge of RB. A Hardware Reset during an Erase or Program operation will corrupt the data being programmed or the blocks being erased. See Table 13: Reset/Block Temporary Unprotect AC Characteristics and Figure 13: Reset/Block Temporary Unprotect AC Waveforms. Holding RP at VID will temporarily unprotect the previously protected blocks in the memory. Program and Erase operations on all blocks will be possible. The transition of RP from VIH to VID must slower than tPHPHH. When RP is returned from VID to VIH all blocks temporarily unprotected will be again protected. 2.8 VCC Supply Voltage The power supply for all operations (Read, Program and Erase). A 0.1µF capacitor should be connected between the VCC Supply Voltage pin and the VSS Ground pin to decouple the current surges from the power supply. The PCB track widths must be sufficient to carry the currents required during program and erase operations, ICC3 2.9 VSS Ground VSS is the reference for all voltage measurements. |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |