| Electronic Components Datasheet Search |
|
M29W008EB Datasheet(PDF) 12 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
M29W008EB Datasheet(HTML) 12 Page - STMicroelectronics |
|
12 / 43 page ![]() 3 Bus Operations M29W008ET, M29W008EB 12/43 3 Bus Operations There are 5 standard bus operations that control the device. These are Bus Read, us Write, Output Disable, Standby and Automatic Standby. See Table 2: Bus Operations, for a summary. Typically glitches of less than 5ns on Chip Enable or Write Enable are ignored by the memory and do not affect the bus operations. 3.1 Standard bus operations 3.1.1 Bus Read Bus Read operations are used to output the contents of the Memory Array, the Electronic Signature, the Status Register or the Block Protection Status. Both Chip Enable E and Output Enable G must be Low in order to read the output of the memory. A new Bus Read operation is initiated either on the falling edge of Chip Enable, E, or on any address transition with E at VIL. See Figure 10: Read Mode AC Waveforms, and Table 10: Read AC Characteristics for details of the timing requirements. 3.1.2 Bus Write Bus Write operations are used to write to the Command Interface or to latch input data to be programmed. A valid Bus Write operation begins by setting the desired address on the Address Inputs. The Address Inputs are latched by the Command Interface on the falling edge of Chip Enable or Write Enable, whichever occurs last. The Data Inputs/Outputs are latched by the Command Interface on the rising edge of Chip Enable or Write Enable, whichever occurs first. Output Enable must remain High, VIH, during the whole Bus Write operation. See Figures 11 and 12, Write AC Waveforms and Tables 11 and 12, Write AC Characteristics, for details of the timing requirements. 3.1.3 Output Disable The data outputs are high impedance when the Output Enable G is High with Write Enable W High. 3.1.4 Standby The memory is in Standby mode when Chip Enable, E, is High and the Program/Erase Controller is idle. The Supply Current is reduced to the Standby Supply Current, ICC2, and the outputs are high impedance, independent of the Output Enable G or Write Enable W inputs. 3.1.5 Automatic Standby If CMOS levels (VCC ± 0.2V) are used to drive the bus and if the bus is inactive (no address transition, E = VIL) during 150ns or more, the memory automatically enters a Automatic Standby mode where the Supply Current is reduced to the Standby Supply Current, ICC2. The Inputs/Outputs will still output data if a Bus Read operation is in progress. |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |