KMM372F213CS datasheet(6/20 Pages) SAMSUNG

6 / 20 page

DRAM MODULE

KMM372F213CK/CS

NOTES

An initial pause of 200us is required after power-up followed

by any 8 RAS-only or CAS-before-RAS refresh cycles before

proper device operation is achieved.

Input voltage levels are Vih/Vil. VIH(min) and VIL(max) are

reference levels for measuring timing of input signals. Transi-

tion times are measured between VIH(min) and VIL(max) and

are assumed to be 5ns for all inputs.

Measured with a load equivalent to 1 TTL loads and 100pF.

Voh=2.0V and Vol=0.8V.

Operation within the

tRCD(max) limit insures that tRAC(max)

can be met.

tRCD(max) is specified as a reference point only.

tRCD is greater than the specified tRCD(max) limit, then

access time is controlled exclusively by

tCAC.

Assumes that

tRCD

≥tRCD(max).

This parameter defines the time at which the output achieves

the open circuit condition and is not referenced to VOH or

VOL.

tWCS, tRWD, tCWD and tAWD are non restrictive operating

parameter. They are included in the data sheet as electrical

characteristics only. If

tWCS

≥tWCS(min) the cycle is an early

write cycle and the data out pin will remain high impedance

for the duration of the cycle.

tCWD

≥tCWD(min), tRWD≥tRWD(min) and tAWD≥tAWD (min),

then the cycle is a read-write cycle and the data output will

contain data read from the selected address. If neither of the

above conditions are satisfied, the condition of the data out

is indeterminated.

Either

tRCH or tRRH must be satisfied for a read cycle.

These parameters are referenced to the CAS leading edge in

early write cycles and to the W leading edge in read-write

cycles.

Operation within the

tRAD(max) limit insures that tRAC(max)

can be met.

tRAD(max) is specified as reference point only. If

tRAD is greater than the specified tRAD(max) limit, then

access time is controlled by

tAA.

tCEZ(max), tREZ(max), tWEZ(max) and tOEZ(max) define the

time at which the output achieves the open circuit condition

and are not referenced to output voltage level.

If RAS goes to high before CAS high going, the open circuit

condition of the output is achieved by CAS high going. If CAS

goes to high before RAS high going , the open circuit condi-

tion of the output is achieved by RAS high going.

tASC

≥tCP min

The timing skew from the DRAM to the DIMM resulted from

the addition of buffers.

10.

12.

13.

11.

14.

KMM372F213CS Datasheet(PDF) 6 Page - Samsung semiconductor

KMM372F213CS Datasheet(HTML) 6 Page - Samsung semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Datasheet Download

Link URL