IS25LP064A-RBLE1 datasheet(32/99 Pages) ISSI

32 / 99 page

IS25LP064A/032A

Integrated Silicon Solution, Inc.- www.issi.com

Rev. A

11/06/2015

8.6 FAST READ QUAD OUTPUT OPERATION (FRQO, 6Bh)

The FRQO instruction is used to read memory data on four output pins each at up to a 133 MHz clock.

The FRQO instruction code is followed by three address bytes (A23

– A0) and a dummy byte (8 clocks),

transmitted via the IO0 line, with each bit latched-in during the rising edge of SCK. Then the first data byte

addressed is shifted out on the IO3, IO2, IO1 and IO0 lines, with each group of four bits shifted out at a

maximum frequency fCT, during the falling edge of SCK. The first bit (MSB) is output on IO3, while

simultaneously the second bit is output on IO2, the third bit is output on IO1, etc.

The first byte addressed can be at any memory location. The address is automatically incremented after each

byte of data is shifted out. When the highest address is reached, the address counter will roll over to the

000000h address, allowing the entire memory to be read with a single FRQO instruction. FRQO instruction is

terminated by driving CE# high (VIH).

If a FRQO instruction is issued while an Erase, Program or Write cycle is in process (BUSY=1) the instruction

is ignored and will not have any effects on the current cycle.

IS25LP064A-RBLE1 Datasheet(PDF) 32 Page - Integrated Silicon Solution, Inc