UM2502 Rev 1

24/27

UM2502

FCC and IC Compliance Statements

26

Appendix B

Federal Communications Commission (FCC)

and Industry Canada (IC) Compliance

Statements

B.1

FCC Compliance Statement

Part 15.19

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired

operation.

Part 15.21

Any changes or modifications to this equipment not expressly approved by

STMicroelectronics may cause harmful interference and void the user's authority to operate

this equipment.

Part 15.105

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated in a

commercial environment. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instruction manual, may cause

harmful interference to radio communications. Operation of this equipment in a residential

area is likely to cause harmful interference in which case the user will be required to correct

the interference at his own expense.

Responsible party (in the USA)

Terry Blanchard

Americas Region Legal | Group Vice President and Regional Legal Counsel, The Americas

STMicroelectronics, Inc.

750 Canyon Drive | Suite 300 | Coppell, Texas 75019

USA

Tel: +1 972-466-7845

B.2

IC Compliance Statement

This device complies with FCC and Industry Canada RF radiation exposure limits set forth

for general population for mobile application (uncontrolled exposure). This device must not

be collocated or operating in conjunction with any other antenna or transmitter.

Compliance Statement

Notice: This device complies with Industry Canada licence-exempt RSS standard(s).

Operation is subject to the following two conditions: (1) this device may not cause

interference, and (2) this device must accept any interference, including interference that

may cause undesired operation of the device.