MODEL: R5-NP1

R5-NP1 SPECIFICATIONS

ES-6107 Rev.7 Page 1/5

http://www.m-system.co.jp/

Remote I/O R5 Series

PROFIBUS-DP INTERFACE MODULE

18 (.71)

mm (inch)

90

(3.54)

90

(3.54)

MODEL: R5-NP1[1]

ORDERING INFORMATION

• Code number: R5-NP1[1]

Specify a code from below for [1].

(e.g. R5-NP1/Q)

• Specify the specification for option code /Q

(e.g. /C01)

[1] OPTIONS

blank: none

/Q: With options (specify the specification)

SPECIFICATIONS OF OPTION: Q

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

RELATED PRODUCTS

• PC configurator software (model: R5CON)

• GSD (General Station Description) file

The GSD file and configurator software are downloadable at

M-System’s web site.

A dedicated cable is required to connect the module to the

PC. Please refer to the internet software download site or

the users manual for the PC configurator for applicable

cable types.

GENERAL SPECIFICATIONS

Connection

PROFIBUS: 9-pin D-sub connector, female

(Lock screw No. 4-40 UNC)

Internal bus: Via the Installation Base (model: R5-BS)

Internal power: Via the base (model: R5-BS)

Isolation: PROFIBUS to internal bus or internal power

RUN indicator: Bi-color (green/red) LED (refer to the

instruction manual)

ERR indicator: Bi-color (green/red) LED (refer to the

instruction manual)

Data allocation: Mode 1 or 2 set with the side DIP switch

PROFIBUS COMMUNICATION

Interface: PROFIBUS-DP, slave (RS-485 isolation)

Max. baud rate: 12 Mbps

Transmission cable: Approved for PROFIBUS-DP

Station address setting: Rotary switch; 00 – 7E

(The station address is programmed to 7E if a larger

number is set on the switches.)

•Sync Mode, Freeze Mode are not supported.

•Special Clear Mode (Fail Safe Mode) is not supported.

However, when the R5-NP1 is initialized (when the power is

turned on), the output of connected output modules is

cleared by value “0”: the discrete outputs are turned off;

the analog outputs are reset to 0 %.

INSTALLATION

Operating temperature: -10 to +55°C (14 to 131°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Atmosphere: No corrosive gas or heavy dust

Mounting: Installation Base (model: R5-BS)

Weight: 100 g (3.53 oz)

PERFORMANCE

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength: 2000 V AC @1 minute (PROFIBUS to

internal bus or internal power)

STANDARDS & APPROVALS

EU conformity:

EMC Directive

EMI EN 61000-6-4

EMS EN 61000-6-2

RoHS Directive

EN 50581