STM32G041C6 datasheet(32/121 Pages) STMICROELECTRONICS

32 / 121 page

Functional overview

STM32G041x6/x8

32/121

DS12993 Rev 3

The LPUART interface can be served by the DMA controller.

3.23

Serial peripheral interface (SPI)

The device contains two SPIs running at up to 32 Mbits/s in master and slave modes. It

supports half-duplex, full-duplex and simplex communications. A 3-bit prescaler gives eight

master mode frequencies. The frame size is configurable from 4 bits to 16 bits. The SPI

peripherals support NSS pulse mode, TI mode and hardware CRC calculation.

The SPI peripherals can be served by the DMA controller.

The I2S interface mode of the SPI peripheral (if supported, see the following table) supports

four different audio standards can operate as master or slave, in half-duplex communication

mode. It can be configured to transfer 16 and 24 or 32 bits with 16-bit or 32-bit data

resolution and synchronized by a specific signal. Audio sampling frequency from 8 kHz up to

192 kHz can be set by an 8-bit programmable linear prescaler. When operating in master

mode, it can output a clock for an external audio component at 256 times the sampling

frequency.

3.24

Development support

3.24.1

Serial wire debug port (SW-DP)

An Arm SW-DP interface is provided to allow a serial wire debugging tool to be connected to

the MCU.

Table 10. SPI/I2S implementation

SPI features(1)

1. X = supported.

SPI1

SPI2

Hardware CRC calculation

Rx/Tx FIFO

NSS pulse mode

I2S mode

TI mode

STM32G041C6 Datasheet(PDF) 32 Page - STMicroelectronics