A111 Pulsed Coherent Radar (PCR)

Datasheet, v2.8

Page 27 of 35

2022-06-22

© 2022 Copyright by Acconeer

10.2FCC Approval

Hereby, Acconeer declares that the A111 sensor has modular approval granted by FCC.

Testing for the modular approval of the A111 has been performed using a binary file which represents

highest Tx emission configuration. This test binary is available in the software provided by Acconeer

and can be used for certification purposes.

The A111 sensor meets the title 47 of the Code of Federal Regulations, part 15 section 15.255 for

intentional radiators operating in the 57-71 GHz band for the following type of applications.

- Field disturbance sensor employed for fixed operations.

- Short range device for interactive motion sensing.

Warning: The end user needs to maintain 20 cm distance to radiating parts of the device.

FCC ID: 2AQ6KA1001

The host product manufacturer is responsible for compliance to any other FCC rules that apply to the

host not covered by the modular transmitter grant of certification.

10.2.1 FCC Regulatory Notes

Modifications

Acconeer has not approved any changes to this device. Any changes or modifications to this device

could invalid the FCC approval.

Interference statement

This device complies with Part 15 of the FCC rules. Operation is subject to the following two

conditions: (1) this device may not cause interference, and (2) this device must accept any

interference, including interference that may cause undesired operation of the device.

RF exposure

This device complies with the FCC radiation exposure limits set forth for an uncontrolled

environment. Co-location of this module with other transmitters that operate simultaneously are

required to be evaluated using the FCC multi-transmitter procedures.

MPE RF exposure testing is not needed as the available maximum time-averaged power of the module

is no more than 1 mW, according to 47 CFR 1.1307(b)(3)(i)(A).

Labelling requirements for the host device

The host device shall be labelled to identify the modules within the host device, which means that the

host device shall be labelled to display the FCC ID of the module preceded by words "Contains

transmitter module" or "Contains", E.g.

Contains FCC ID: 2AQ6KA1001