NE56632-29D datasheet(10/16 Pages) PHILIPS

10 / 16 page

Philips Semiconductors

Product data

NE56632-XX

Active-LOW system reset with adjustable delay time

2002 Mar 25

TIMING DIAGRAM

The timing diagram in Figure 23 depicts the operation of the device.

Letters A–N on the TIME axis indicates specific events.

At “A”, VCC begins to increase. Also the VOUT voltage initially

increases but abruptly decreases when VCC reaches the level

(approximately 0.65 V) that activates the internal bias circuitry and

RESET is asserted.

At “B”, VCC reaches the threshold level of VSH. At this point the

delay time, tPLH is initiated while VCC rises above VSH to its normal

operating level. The VOUT voltage remains in a low voltage state.

At “C”, VCC is above VSL and the delay time elapses. At this

instant, the IC releases the hold on the VOUT reset. The reset output

then goes HIGH (assuming the reset pull-up resistor RPU is

connected to VCC). In a microprocessor based system these events

release the reset from the microprocessor, allowing the

microprocessor to function normally.

D-E:

At “D”, VCC begins to fall, causing VOUT to follow. VCC

continues to fall until the VSL undervoltage detection threshold is

reached at “E”. This causes a reset signal to be generated (VOUT

goes LOW).

E-F:

Between “E” and “F”, VCC continues to fall and then starts

rising.

At “F”, VCC rises to the VSH level. Once again, the device

initiates the delay timer.

F-G:

VCC rises above VSH and returns to normal. At “G”, the delay

(tPLH) times out and once again, then it releases the hold on the

VOUT reset.

G-H:

At “G”, VCC is above the upper threshold and begins to fall,

causing VOUT to follow it. As long as VCC remains above the VSH,

no reset signal will be generated.

At event “H”, VCC falls until the VSL undervoltage detection

threshold is reached. At this level, a RESET signal is generated and

VOUT goes LOW.

H-I:

Between “H” and “I”, VCC continues to fall and then starts to

rise rising. VCC rises to the VSH level at “I”, where the delay time is

again initiated.

I-J:

Between “I” and “J”, VCC rises above VSH to VCC normal and

then falls back to VSL level at “J”. At “J”, the reset signal is

reasserted before the delay time has elapsed. The time between “I”

and “J” is less than tPLH (reset delay time). Thus, the reset is not

released and the reset output remains LOW.

K–L:

Between “K” and “L”, VCC rises again back to normal

operating level causing the reset delay to be initiated at “K” and the

reset to be released at “L”.

At “M”, VCC falls to VSL where the reset is asserted (VOUT

Reset goes LOW).

At “N”, the VCC voltage has decreased until normal internal

circuit bias is unable to maintain a VOUT reset. As a result, VCC may

rise to less than 0.65 V. As VCC decreases further, the VOUT reset

also decreases to zero.

Vhys

tPLH

D E

(RESET)

VOUT

tPLH

< tPLH

VSH

VSL

VCC

SL01606

Figure 23. Timing diagram.

NE56632-29D Datasheet(PDF) 10 Page - NXP Semiconductors

NE56632-29D Datasheet(HTML) 10 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Datasheet Download

Link URL