| Electronic Components Datasheet Search |
|
AFEX8201 Datasheet(PDF) 43 Page - Texas Instruments |
|
|
|||||||||||||||||||||||||||||
AFEX8201 Datasheet(HTML) 43 Page - Texas Instruments |
|
43 / 95 page ![]() 7.4 Device Functional Modes 7.4.1 Register Built-In Self-Test (RBIST) The AFEx8201 feature a register built-in self-test (RBIST) that runs on all the registers listed in Table 7-7 through a CRC calculation in the order the registers are listed in Table 7-7. If the final CRC value is zero, then no error is present in the configuration of the registers. If a non-zero value is present at the end of the calculation, then there is a configuration error. The polynomial used has a Hamming distance (HD) of 4 for data packets up to 2048 bits. With HD = 4, the CRC detects any combination of 4-bit errors within the stored data. Independently calculate the expected CRC polynomial and store the output in the RBIST_CRC register at 3Fh. The final value of the CRC is read in the CRC_RD register at address 3Eh. This value is updated while either an RBIST or shadow load is running. Both the RBIST and OTP memory use the same CRC calculation engine and polynomial. The value in the CRC_RD register remains constant until another RBIST or SHADOWLOAD in TRIGGER register (0Ah) is triggered. Set TRIGGER.RBIST to 1 to initiate an RBIST. The TRIGGER.RBIST bit stays high as long as the RBIST is running and clears when the self-test is complete. While the RBIST is running, the registers cannot be written to or read. Send NOP commands and monitor the RBIST SDO status bit to determine if the RBIST has completed. In UBM, the RBIST does not interfere with register communication. UBM communication is slow enough that the RBIST completes before any following read or write command. Set the GEN_STATUS.RBIST_MODE bit to 1 to enable the RBIST. This bit is sticky until the GEN_STATUS register is read. The 16-bit CRC used to generate the RBIST is the openSAFETY (0x755B) with the following polynomial: x16 + x14 + x13 + x12 + x10 + x8 + x6 + x4 + x3 + x1 + 1. The list of registers covered by the RBIST is listed in Table 7-7. Not all registers feature the RBIST. Table 7-7. List of Registers Covered by RBIST ADDR (HEX) REGISTER RESET (HEX) 01h DAC_DATA 0000h 02h CONFIG 0036h 03h DAC_CFG 0B00h 04h DAC_GAIN 8000h 05h DAC_OFFSET 0000h 06h DAC_CLR_CODE 0000h 08h ADC_CFG 8810h 09h ADC_INDEX_CFG 0080h 0Bh SPECIAL_CFG 0000h 0Dh RESERVED 0100h 10h ALARM_ACT 8020h 11h WDT 0018h 12h AIN0_THRESHOLD FF00h 13h AIN1_THRESHOLD FF00h 14h TEMP_THRESHOLD FF00h 1Bh GPIO_CFG 00FFh 1Dh ALARM_STATUS_MASK EFDFh 1Eh GEN_STATUS_MASK FFFFh 3Fh RBIST_CRC 0000h www.ti.com AFE78201, AFE88201 SLASF44 – MAY 2023 Copyright © 2023 Texas Instruments Incorporated Submit Document Feedback 43 Product Folder Links: AFE78201 AFE88201 |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |