TMP86FS23UG datasheet(72/252 Pages) TOSHIBA

72 / 252 page

Page 60

5. I/O Ports

5.5 Port P6 (P67 to P60)

TMP86FS23UG

Figure 5-6 Port P6

Note 1: The port placed in input mode reads the pin input state. Therefore, when the input and output modes are used

together, the output latch contents for the port in input mode might be changed by executing a bit manipulation

instruction.

Note 2: When used as an analog inport, be sure to clear the corresponding bit of P6CR2 to disable the port input.

Note 3: Do not set the output mode (P6CR1 = “1” ) for the pin used as a analog input pin.

Note 4: Pins not used for analog input can be used as I/O ports. During AD conversion, output instructions should not be

executed to keep a precision. In addition, a variable signal should not be input to a port adjacent to the analog

input during AD conversion.

Control input

Analog input

Data output (P6DR)

Data input (P6DR)

STOP

OUTEN

AINDS

SAIN

P6CR2i input

P6CR1i input

P6CR2i

P6CR1i

P6i

Note 1: i = 0 to 3, j = 4 to 7, k = 2 to 5

Note 2: STOP is bit 7 in SYSCR1

Note 3: SAIN is AD input select signal.

Note 4: STOPk is input select signal

in a key on wake up.

Analog input

Key on wake up

Data output (P6DR)

Data input (P6DR)

STOP

STOPk

OUTEN

AINDS

SAIN

P6CR2j input

P6CR1j input

P6CR2j

P6CR1j

P6j

TMP86FS23UG Datasheet(PDF) 72 Page - Toshiba Semiconductor

TMP86FS23UG Datasheet(HTML) 72 Page - Toshiba Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL