PCA2129TSLASHQ900SLASH2 datasheet(23/84 Pages) NXP

23 / 84 page

PCA2129

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 5 — 19 December 2014

23 of 84

NXP Semiconductors

PCA2129

Automotive accurate RTC with integrated quartz crystal

8.7 Reset function

The PCA2129 has a Power-On Reset (POR) and a Power-On Reset Override (PORO)

function implemented.

8.7.1 Power-On Reset (POR)

The POR is active whenever the oscillator is stopped. The oscillator is considered to be

stopped during the time between power-on and stable crystal resonance (see Figure 11).

This time may be in the range of 200 ms to 2 s depending on temperature and supply

voltage. Whenever an internal reset occurs, the oscillator stop flag is set (OSF set

logic 1).

The OTP refresh (see Section 8.3.2 on page 13) should ideally be executed as the first

instruction after start-up and also after a reset due to an oscillator stop.

(1) Theoretical state of the signals since there is no power.

(2) The oscillator stop flag (OSF), set logic 1, indicates that the oscillation has stopped and a reset has

occurred since the flag was last cleared (OSF set logic 0). In this case, the integrity of the clock

information is not guaranteed. The OSF flag is cleared by command.

Fig 10. Power failure event due to battery discharge: reset occurs

PCA2129T/Q900/2 Datasheet(PDF) 23 Page - NXP Semiconductors