SN260 datasheet(48/88 Pages) STMICROELECTRONICS

48 / 88 page

EmberZNet serial protocol

SN260

48/88

EMBER_SLEEP_INTERRUPTED

0x85

Sleeping (for a duration) has been abnormally

interrupted and exited prematurely.

EMBER_PHY_TX_UNDERFLOW

0x88

Transmit hardware buffer underflowed.

EMBER_PHY_TX_INCOMPLETE

0x89

Transmit hardware did not finish transmitting a packet.

EMBER_PHY_INVALID_CHANNEL

0x8A

An unsupported channel setting was specified.

EMBER_PHY_INVALID_POWER

0x8B

An unsupported power setting was specified.

EMBER_PHY_TX_BUSY

0x8C

Packet cannot be transmitted because the physical MAC

layer is currently transmitting a packet. (This is used for

the MAC backoff algorithm.)

EMBER_PHY_UNKNOWN_RADIO_TYPE

0x8D

The software installed on the hardware doesn't

recognize the hardware radio type.

EMBER_PHY_OSCILLATOR_CHECK_FAILED

0x8E

The software installed on the hardware doesn't

recognize the hardware radio type.

EMBER_PHY_PARTIAL_PACKET

0x8F

PHY did not receive the entire packet it was expecting

from the radio.

EMBER_NETWORK_UP

0x90

Stack software has completed initialization and is ready

to send and receive packets over the air.

EMBER_NETWORK_DOWN

0x91

Network is not operating.

EMBER_NETWORK_PENDING_ACTIVITY

0x92

Network has activity pending and should not be shut

down.

EMBER_NOT_JOINED

0x93

Node has not joined a network.

EMBER_JOIN_FAILED

0x94

An attempt to join a network failed.

EMBER_INVALID_SECURITY_LEVEL

0x95

The chosen security level (the value of

EMBER_SECURITY_LEVEL

) is not supported by the

stack.

EMBER_MOVE_FAILED

0x96

After moving, a mobile node's attempt to re-establish

contact with the network failed.

EMBER_NETWORK_BUSY

0xA1

A message cannot be sent because the network is

currently overloaded.

EMBER_NODEID_INVALID

0xA2

A datagram was sent to a node and the EUI64 address

in the datagram did not match the node's EUI64

address. The NodeId was invalid.

EMBER_INVALID_ENDPOINT

0xA3

The application tried to send a message using an

endpoint that it has not defined.

EMBER_BINDING_HAS_CHANGED

0xA4

The application tried to use a binding that has been

remotely modified and the change has not yet been

reported to the application.

EMBER_STACK_AND_HARDWARE_MISMATCH

0xB0

A critical and fatal error indicating that the version of the

stack trying to run does not match with the chip it is

running on. The software (stack) on the chip must be

replaced with software that is compatible with the chip.

Table 30.

EmberStatus (continued)

Structure

Field

Description

SN260 Datasheet(PDF) 48 Page - STMicroelectronics

SN260 Datasheet(HTML) 48 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88

Datasheet Download

Link URL