THS4302RGTR datasheet(12/28 Pages) TI2

12 / 28 page

www.ti.com

APPLICATION INFORMATION

High-Speed Operational amplifiers

Applications Section Contents

THS4302

100

Ω

49.9

Ω

µF

47 pF

0.1

µF

VS+

50-

Ω Source

µF

47 pF

0.1

µF

VS−

30.1

Ω

30.1

Ω

FB = Ferrite Bead

THS4302

SLOS403H – OCTOBER 2002 – REVISED AUGUST 2006

generator. The 50-

Ω series resistor at the VO terminal

in addition to the 50-

Ω load impedance of the test

equipment, provides a 100-

Ω load. The total 100-Ω

The THS4302 fixed-gain operational amplifier set new

load at the output, combined with the 250-

Ω total

performance levels, combining low distortion, high

feedback network load, presents the THS4302 with

slew rates, low noise, and a gain bandwidth in excess

an effective output load of 71

Ω for the circuit of

of 2 GHz. To achieve the full performance of the

Figure 44.

amplifier,

careful

attention

must

paid

printed-circuit board layout and component selection.

INTERNAL FIXED RESISTOR VALUES

In addition, the devices provide a power-down mode

DEVICE

GAIN (V/V)

with the ability to save power when the amplifier is

THS4302

200

inactive.

• Wideband, Noninverting Operation

• Single Supply Operation

• Saving Power With Power-Down Functionality

• Driving an ADC With the THS4302

• Driving Capacitive Loads

• Power Supply Decoupling Techniques and

Recommendations

• Board Layout

• Printed-Circuit Board Layout Techniques for

Optimal Performance

• PowerPAD Design Considerations

• PowerPAD PCB Layout Considerations

• Thermal Analysis

• Design Tools

• Evaluation Fixtures and Application Support

Information

• Additional Reference Material

Figure 44. Wideband, Noninverting

Gain Configuration

• Mechanical Package Drawings

WIDEBAND, NONINVERTING OPERATION

SINGLE SUPPLY OPERATION

The THS4302 is a fixed-gain voltage feedback

The THS4302 is designed to operate from a single

operational amplifier, with power-down capability,

3-V to 5-V power supply. When operating from a

designed to operate from a single 3-V to 5-V power

single power supply, care must be taken to ensure

supply.

the input signal and amplifier are biased appropriately

to allow for the maximum output voltage swing. The

Figure 44 is the noninverting gain configuration used

circuits shown in Figure 45 demonstrate methods to

to demonstrate the typical performance curves. Most

configure an amplifier in a manner conducive for

of the curves were characterized using signal sources

single supply operation.

with 50-

Ω source impedance, and with measurement

equipment presenting a 50-

Ω load impedance. In

Figure 44, the 49.9-

Ω shunt resistor at the VIN

terminal matches the source impedance of the test

Submit Documentation Feedback

Product Folder Link(s): THS4302

THS4302RGTR Datasheet(PDF) 12 Page - Texas Instruments

THS4302RGTR Datasheet(HTML) 12 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Datasheet Download

Link URL