16

LMH6574

SNCS103E – NOVEMBER 2004 – REVISED AUGUST 2018

www.ti.com

Product Folder Links: LMH6574

Submit Documentation Feedback

Copyright © 2004–2018, Texas Instruments Incorporated

7.3 Device Functional Modes

7.3.1 SD vs EN

The LMH6574 has both shutdown and disable capability. The shutdown feature affects the entire chip, whereas

the disable function only affects the output buffer. When in shutdown mode, minimal power is consumed. The

shutdown function is very fast, but causes a very brief spike of about 400 mV to appear on the output. When in

shutdown mode the LMH6574 consumes only 1.8 mA of supply current. For maximum input to output isolation

use the shutdown function.

The EN pin only disables the output buffer which results in a substantially reduced output glitch of only 50 mV.

While disabled the chip consumes 4.7 mA, considerably more than when shutdown. This is because the input

buffers are still active. For minimal output glitch use the EN pin. Also, care should be taken to ensure that, while

in the disabled state, the voltage differential between the active input buffer (the one selected by pins A0 and A1)

and the output pin stays less than 2V. As the voltage differential increases, input to output isolation decreases.

Normally this is not an issue. See Multiplexer Expansion for further details.

To reduce the output glitch when using the SD pin, switch the EN pin at least 10 ns before switching the SD pin.

This can be accomplished by using an RC delay circuit between the two pins if only one control signal is

available.

Logic inputs "SD" and "EN" will revert to the "High", while "A0" and "A1" will revert to the "Low" state when left

floating.