TCA9538

Peripheral

Devices

I2C or SMBus

Master

(e.g. Processor)

SDA

SCL

INT

P0

P1

RESET

P2

P3

P4

P5

P6

P7

VCC

A1

GND

A0

•

,

ENABLE, or

control

inputs

•

or

status

outputs

• LEDs

RESET

INT

Product

Folder

Sample &

Buy

Technical

Documents

Tools &

Software

Support &

Community

An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,

intellectual property matters and other important disclaimers. PRODUCTION DATA.

TCA9538

SCPS199D – AUGUST 2014 – REVISED OCTOBER 2016

TCA9538 Low Voltage 8-Bit I2C and SMBus Low-Power I/O Expander with Interrupt

Output, Reset, and Configuration Registers

1

1 Features

1

•

Low Standby Current Consumption

•

I2C to Parallel Port Expander

•

Open-Drain Active-Low Interrupt Output

•

Active-Low Reset Input

•

Operating Power-Supply Voltage Range of 1.65 V

to 5.5 V

•

5-V Tolerant I/O Ports

•

400-kHz Fast I2C Bus

•

Two Hardware Address Pins Allow up to Four

Devices on the I2C/SMBus

•

Input and Output Configuration Register

•

Polarity Inversion Register

•

Power-Up With All Channels Configured as Inputs

•

No Glitch on Power Up

•

Noise Filter on SCL/SDA Inputs

•

Latched Outputs With High-Current Drive

Maximum Capability for Directly Driving LEDs

•

Latch-Up Performance Exceeds 100 mA Per

JESD 78, Class II

•

ESD Protection Exceeds JESD 22

–

2000-V Human-Body Model (A114-A)

–

1000-V Charged-Device Model (C101)

2 Applications

•

Servers

•

Routers (Telecom Switching Equipment)

•

Personal Computers

•

Personal Electronics (example: Gaming Consoles)

•

Industrial Automation

•

Products With GPIO-Limited Processors

3 Description

The TCA9538 is a 16-pin device that provides 8 bits

of general purpose parallel input and output (I/O)

expansion for the two-line bidirectional I2C bus (or

SMBus) protocol. The device can operate with a

power supply voltage ranging from 1.65 V to 5.5 V.

The device supports both 100-kHz (Standard-mode)

and 400-kHz (Fast-mode) clock frequencies. I/O

expanders such as the TCA9538 provide a simple

solution

when

additional

I/Os

are

needed

for

switches, sensors, push-buttons, LEDs, fans, etc.

The features of the TCA9538 include an interrupt that

is generated on the INT pin whenever an input port

changes state. The A0 and A1 hardware selectable

address pins allow up to four TCA9538 devices on

the same I2C bus. The device can also be reset to its

default sate by using the RESET feature or by cycling

the power supply and causing a power-on reset.

Device Information(1)

PART NUMBER

PACKAGE

BODY SIZE (NOM)

TCA9538

TSSOP (16)

5.00 mm × 4.40 mm

SSOP (16)

6.20 mm × 5.30 mm

(1) For all available packages, see the orderable addendum at

the end of the datasheet.

Simplified Block Diagram