P-NUCLEO-USB002

P-NUCLEO-USB002 - System architecture

DocID030140 Rev 1

3/5



An STM32F072RBT6 32-bit microcontroller based on the ARM Cortex-M0 with 128 kB

Flash memory, 16 kB of SRAM, USB 2.0 full speed data interface in LQFP64 package



Two types of extension resources:



Arduino Uno Revision 3 connectivity



ST morpho extension pin headers for full access to all STM32 I/Os



On-board ST-LINK/V2-1 debugger/programmer with SWD connector:



selection-mode switch to use the kit as a standalone ST-LINK/V2-1



Flexible board power supply:



USB VBUS on Type-B connector or external source



Power management access point



Three LEDs:



USB communication (LD1), user LED (LD2) and power LED (LD3)



Two push buttons: USER and RESET



USB re-enumeration capability: three different interfaces supported on USB



Virtual Com port (the NUCLEO-F072RB in the kit has a different solder bridge

configuration to the standalone board)



Mass storage



Debug port



Supported by a wide range of integrated development environments (IDEs), including

IAR™, Keil® and GCC