Receiver Switching Characteristics

Over recommended operating supply and temperature ranges unless otherwise specified.

Symbol

Parameter

Min

Typ

Max

Units

CLHT

CMOS/TTL Low-to-High Transition Time (Figure 4), Rx data out

1.52

2.0

ns

CMOS/TTL Low-to-High Transition Time (Figure 4), Rx clock out

0.5

1.0

ns

CHLT

CMOS/TTL High-to-Low Transition Time (Figure 4), Rx data out

1.7

2.0

ns

CMOS/TTL High-to-Low Transition Time (Figure 4), Rx clock out

0.5

1.0

ns

RCOP

RxCLK OUT Period (Figure 7)

8.928

T

30.77

ns

RCOH

RxCLK OUT High Time (Figure 7)(Note 4)

f = 112 MHz

3.5

ns

f = 85 MHz

4.5

ns

RCOL

RxCLK OUT Low Time (Figure 7)(Note 4)

f = 112 MHz

3.5

ns

f = 85 MHz

4.5

ns

RSRC

RxOUT Setup to RxCLK OUT (Figure 7)(Note 4)

f = 112 MHz

2.4

ns

f = 85 MHz

3.0

ns

RHRC

RxOUT Hold to RxCLK OUT (Figure 7)(Note 4)

f = 112 MHz

3.4

ns

f = 85 MHz

4.75

ns

RPLLS

Receiver Phase Lock Loop Set (Figure 9)10

ms

RPDD

Receiver Powerdown Delay (Figure 11)1

µs

RSKM

Receiver Skew Margin (Figure 12) (Notes 4, 6),

f = 112 MHz

170

ps

f = 100 MHz

170

240

ps

f = 85MHz

300

350

ps

f = 66MHz

300

350

ps

Note 4: The Minimum and Maximum Limits are based on statistical analysis of the device performance over voltage and temperature ranges. This parameter is

functionally tested on Automatic Test Equipment (ATE). ATE is limited to 85MHz. A sample of characterization parts have been bench tested at 112MHz to verify

functional performance.

Note 5: The limits are based on bench characterization of the device’s jitter response over the power supply voltage range. Output clock jitter is measured with a

cycle-to-cycle jitter of ±3ns applied to the input clock signal while data inputs are switching (see figures 15 and 16). A jitter event of 3ns, represents worse case jump

in the clock edge from most graphics VGA chips currently available. This parameter is used when calculating system margin as described in AN-1059.

Note 6: Receiver Skew Margin is defined as the valid data sampling region at the receiver inputs. This margin takes into account transmitter output pulse positions

(min and max) and the receiver input setup and hold time (internal data sampling window - RSPOS). This margin allows for LVDS interconnect skew, inter-symbol

interference (both dependent on type/length of cable) and clock jitter.

RSKM

≥ cable skew (type, length) + source clock jitter (cycle to cycle).

www.national.com

6