9

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ATTACHING THE BREATHING TUBE

Insert the tube connector into the

blower receptacle until snug and

then turn the connector 1/8 turn to

the right to lock it into place.

1. Welding helmet

2. Face seal

3. Headgear terminal

4. Breathing tube terminal

5. Breathing tube

6. Breathing tube terminal

7. Blower receptacle

8. Belt

9. Blower body

Insert the breathing tube terminal into the headgear terminal and turn the tube

clockwise until the breathing tube locks in position.

TESTING THE AIR FLOW ALARM

Disconnecting the breathing tube from the hood. Start the blower and block the air

flow by placing your hand over the end of the breathing tube. Continue blocking the

air flow until the alarm sounds and the blower vibrates. If the alarm does not sound

and the blower does not vibrate, check the battery and filter element.

USING THE BLOWER CONTROLS

1. On/Off button

2. Low speed indicator

3. High speed indicator

4. Danger indicator

5. Battery level indicator

To start, press the On

button for 1 second until

the blower starts.

• The Danger, Low Speed, High Speed Indicator lights come on, then go out,

the alarm sounds, and the blower vibrates momentarily.

The blower always starts at the low speed. Press the SELECT button to switch

between Low and High Speeds.