PIC24FJ64GA006 datasheet(3/10 Pages) MICROCHIP

3 / 10 page

DS80330A-page 3

PIC24FJ128GA010

11. Module: A/D

Gain error may be as high as 5 LSbs for external

references (VREF+ and VREF-) and 6 LSbs for

internal reference (AVDD and AVSS).

Work around

Determine gain error from a known reference

voltage and compensate the A/D result in

software.

Date Codes that pertain to this issue:

All engineering and production devices.

12. Module: A/D

With the External Interrupt 0 (INT0) selected to start

an A/D conversion (SSRC<2:0> = 001), the device

may not wake-up from Sleep or Idle mode if more

than one conversion is selected per interrupt

(SMPI<3:0> <> 0000). Interrupts are generated

correctly if the device is not in a Sleep or Idle mode.

Work around

Configure the A/D to generate an interrupt after

every

conversion

(SMPI<3:0> = 0000). Use

another wake-up source, such as the WDT or

another interrupt source, to exit the Sleep or Idle

mode. Alternatively, perform A/D conversions in

Run mode.

Date Codes that pertain to this issue:

All engineering and production devices.

13. Module: SPI

The Enhanced SPI modes, selected by setting the

Enhanced

Buffer

Enable

bit,

SPIBEN

(SPIxCON2<0>), are not available.

Work around

Use Standard SPI mode by clearing the SPI

Enhanced Buffer Enable bit, SPIBEN.

Date Codes that pertain to this issue:

All engineering and production devices.

14. Module: SPI

Master mode receptions using the SPI1 and SPI2

modules may not function correctly for bit rates

above 8 Mbps if the master has the SMP bit

(SPIxCON1<9>) cleared (master samples data at

the middle of the serial clock period).

In this case, the data transmitted by the slave is

received, shifted right by one bit, by the master.

For example, if the data transmitted by the slave

was 0xAAAA, the data received by the master

would be 0x5555 (0xAAAA shifted right by one bit).

Work around

Users may set up the SPI module so that the bit

rate is 8 Mbps or lower.

Alternatively, the bit rate can be configured higher

than 8 Mbps, but the SMP bit (SPIxCON1<9>) of

the SPI master must be set (master samples data

at the end of the serial clock period).

Date Codes that pertain to this issue:

All engineering and production devices.

15. Module: SPI

A frame synchronization pulse may not be output

in SPI Master mode if the pulse is selected to

coincide with the first bit clock (SPIFE = 1). SCKx

and SDOx waveforms are not affected.

Work around

Select the frame sychronization pulses to proceed

the first bit clock (SPIFE = 0). The frame pulses

will output correctly as described in the product

data sheet.

Date Codes that pertain to this issue:

All engineering and production devices.

PIC24FJ64GA006 Datasheet(PDF) 3 Page - Microchip Technology

PIC24FJ64GA006 Datasheet(HTML) 3 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10

Datasheet Download

Link URL