H8S2245 datasheet(599/818 Pages) RENESAS

599 / 818 page

Section 18 Power-Down Modes

Rev.3.00 Mar. 26, 2007 Page 557 of 772

REJ09B0355-0300

18.2

18.2.1

Standby Control Register (SBYCR)

SSBY

R/W

STS2

R/W

STS1

R/W

STS0

R/W

OPE

R/W

—

Bit

Initial value

R/W

SBYCR is an 8-bit readable/writable register that performs software standby mode control.

SBYCR is initialized to H'08 by a reset and in hardware standby mode. It is not initialized in

software standby mode.

Bit 7—Software Standby (SSBY): Specifies a transition to software standby mode. Remains set

to 1 when software standby mode is released by an external interrupt, and a transition is made to

normal operation. The SSBY bit should be cleared by writing 0 to it.

Bit 7

SSBY

Description

Transition to sleep mode after execution of SLEEP instruction

(Initial value)

Transition to software standby mode after execution of SLEEP instruction

Bits 6 to 4—Standby Timer Select 2 to 0 (STS2 to STS0): These bits select the time the MCU

waits for the clock to stabilize when software standby mode is cleared by an external interrupt.

With crystal oscillation, refer to table 18.4 and make a selection according to the operating

frequency so that the standby time is at least 8 ms (the oscillation stabilization time). With an

external clock, any selection can be made.

H8S2245 Datasheet(PDF) 599 Page - Renesas Technology Corp