Electronic Components Datasheet Search
  New Zealand  ▼
ALLDATASHEET.CO.NZ

X  

EVAL-ADF7901EB Datasheet(PDF) 9 Page - Analog Devices

Part # EVAL-ADF7901EB
Description  High Performance ISM Band OOK/FSK Transmitter IC
PDF  12 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
Manufacturer  AD [Analog Devices]
Direct Link  http://www.analog.com
Logo AD - Analog Devices

EVAL-ADF7901EB Datasheet(HTML) 9 Page - Analog Devices

Back Button EVAL-ADF7901EB Datasheet HTML 4Page - Analog Devices EVAL-ADF7901EB Datasheet HTML 5Page - Analog Devices EVAL-ADF7901EB Datasheet HTML 6Page - Analog Devices EVAL-ADF7901EB Datasheet HTML 7Page - Analog Devices EVAL-ADF7901EB Datasheet HTML 8Page - Analog Devices EVAL-ADF7901EB Datasheet HTML 9Page - Analog Devices EVAL-ADF7901EB Datasheet HTML 10Page - Analog Devices EVAL-ADF7901EB Datasheet HTML 11Page - Analog Devices EVAL-ADF7901EB Datasheet HTML 12Page - Analog Devices  
Zoom Inzoom in Zoom Outzoom out
 9 / 12 page
background image
ADF7901
Rev. A| Page 9 of 12
CIRCUIT DESCRIPTION
Table 4.
Frequency (MHz)
FSK3
FSK2
FSK1
OOK_SEL
369.5
0
0
0
0
371.1
0
0
1
0
375.3
0
1
0
0
376.9
0
1
0
0
384.0
Don’t
care
Don’t
care
Don’t
care
1
388.3
1
0
0
0
391.5
1
0
1
0
394.3
1
1
0
0
395.9
1
1
1
0
LOOP FILTER
The loop filter integrates the current pulses from the charge
pump to form a voltage that tunes the output of the VCO to the
desired frequency. It also attenuates spurious levels generated by
the PLL. The recommended loop filter design for this circuit is
297 kHz. This is based on the trade-off between attenuation of
beat note spurs and the need to minimize chirp when the PA is
turned on.
CHARGE
PUMP OUT
VCO
R2 = 6.2k
Ω
C3 = 10pF
C1 = 33pF
C2 = 390pF
R1 = 3k
Ω
Figure 7.
Improved spurious performance in FSK mode can be achieved
by using a narrower loop bandwidth. For a data rate of 20 kbps,
a loop bandwidth of roughly 50 kHz would be suitable. The
following components give a loop bandwidth of 51.1 kHz:
C1 = 680 pF
C2 = 15 nF
C3 = 180 pF
R1 = 510 Ω
R2 = 6.2 kΩ
ADIsimPLL is a free software tool offered by Analog Devices
for assistance in designing with ADI’s frequency synthesizers
and ISM band transmitters. To select the correct loop filter
components for use with the ADF7901, open a project for the
ADF7012 device. Then, enter the desired output carrier
frequency and loop bandwidth, and use the 870 μA charge
pump current setting.
ADIsimPLL can be downloaded from www.analog.com.
CHANNEL FREQUENCIES
The nine channel frequencies listed in Table 4 are obtainable
from a single 9.8304 MHz crystal reference by changing the
value of the N and F numbers in the fractional PLL, using
control lines FSK1, FSK2, and FSK3. The channel frequency is
given by
FCHANNEL = FREF × (N + F)
However, the VCO is tuned to operate over a frequency range
of 344 MHz to 401 MHz (typically). Therefore, any channel
frequency within this range can be obtained if the required
reference frequency is used. The N and F numbers for each
channel are listed in Table 5, together with the corresponding
channel frequencies for 9.8304 MHz and, for example purposes,
frequencies for 10 MHz. With the 10 MHz reference, the two
largest N settings give channel frequencies above the maximum
VCO output frequency and are therefore invalid.
Frequency deviation is also dependent on reference frequency.
The relationship is given by
FDEV = 58 × (9.8304 MHz)/214
Therefore, the frequency deviation is 34.8 kHz when the
9.8304 MHz reference is used and 35.4 kHz when the 10 MHz
reference is used.
Table 5.
Channel Frequency (MHz)
N
F
9.8304 MHz Ref
10 MHz Ref
37
2406/4096
369.5
375.9
37
3073/4096
371.1
377.5
38
727/4096
375.3
381.8
38
1374/4096
376.9
383.4
39
256/4096
384.0
390.6
39
2048/4096
388.3
395
39
3381/4096
391.5
398.3
40
452/4096
394.3
N/A
40
1118/4096
395.9
N/A



Html Pages

1 2 3 4 5 6 7 8 9 10 11 12


Datasheet Download

Go To PDF Page


Link URL



Does ALLDATASHEET help your business so far?  [ DONATE ] 

About Alldatasheet   |   Advertisement   |   Contact us   |   Privacy Policy   |   Link to Datasheet    |   Link Exchange   |   Manufacturer List
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com