DSPIC33FJ12MC202TESS datasheet(18/304 Pages) MICROCHIP

18 / 304 page

dsPIC33FJ12MC201/202

DS70265E-page 18

2.7

Oscillator Value Conditions on

Device Start-up

If the PLL of the target device is enabled and

configured for the device start-up oscillator, the

maximum oscillator source frequency must be limited

to 4 MHz < FIN < 8 MHz to comply with device PLL

start-up conditions. This means that if the external

oscillator frequency is outside this range, the

application must start-up in the FRC mode first. The

default PLL settings after a POR with an oscillator

frequency outside this range will violate the device

operating speed.

Once the device powers up, the application firmware

can initialize the PLL SFRs, CLKDIV, and PLLDBF to a

suitable value, and then perform a clock switch to the

Oscillator + PLL clock source. Note that clock switching

must be enabled in the device Configuration word.

2.8

Configuration of Analog and

Digital Pins During ICSP

Operations

If MPLAB ICD 2, MPLAB ICD 3, or MPLAB REAL ICE

in-circuit emulator is selected as a debugger, it

automatically initializes all of the A/D input pins (ANx)

as “digital” pins, by setting all bits in the AD1PCFGL

The bits in the register that correspond to the A/D pins

that are initialized by MPLAB ICD 2, MPLAB ICD 3, or

MPLAB REAL ICE in-circuit emulator, must not be

cleared by the user application firmware; otherwise,

communication errors will result between the debugger

and the device.

If your application needs to use certain A/D pins as

analog input pins during the debug session, the user

application must clear the corresponding bits in the

AD1PCFGL register during initialization of the ADC

module.

When MPLAB ICD 2, MPLAB ICD 3, or MPLAB REAL

ICE in-circuit emulator is used as a programmer, the

user application firmware must correctly configure the

AD1PCFGL register. Automatic initialization of this

Failure to correctly configure the register(s) will result in

all A/D pins being recognized as analog input pins,

resulting in the port value being read as a logic ‘0’,

which may affect user application functionality.

2.9

Unused I/Os

Unused I/O pins should be configured as outputs and

driven to a logic-low state.

Alternately, connect a 1k to 10k resistor between VSS

and unused pins and drive the output to logic low.

DSPIC33FJ12MC202TESS Datasheet(PDF) 18 Page - Microchip Technology

DSPIC33FJ12MC202TESS Datasheet(HTML) 18 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL