J T A G

P R OB E S

F OR

S I GN U M

E M ULATO RS

T E CHNI CA L

S P E C IF IC A TION S

3

Caution:

Voltages higher than

3.3V may permanently damage

the low-voltage probe.

Ribbon Cable

D

C

L

FIGURE 5 The dimensions of the ADA-JET-ARM14 probe with a cable extender. L = 63.0 mm (2.5 in.), C =

40.0 mm (1.55 in.) D = 6.0 mm (.24 in.), W = 22.5 mm (.9 in.), H = 11.5 mm (0.45 in.).

Pin 1

A

Cable to Emulator

FIGURE 6 The dimensions of the ADA-JET-

ARM20 probe. Top view. A = 19.3 mm (0.76 in.)

[low-voltage: A = 24.3 mm (0.96 in.)] B = 30.5

mm (1.2 in.)

FIGURE 7 The dimensions of the ADA-JET-ARM20

probe. Side view. C = 22.7 mm (0.88 in.) D = 15.0 mm

(0.59 in.) E = 11.0 mm (0.43 in.)

ADA-JET-ARM20-LV

Your emulator can also be ordered with a low-voltage variant of the JTAG probe (Figure 8), or with both

standard and low-voltage variants. These two variants have identical

pinouts, but slightly differ in dimensions (cf. the caption of Figure 6). The

voltage range of the low-voltage probe is 1.8V – 3.3V (± 10%).

Pin 1