S I GN U M

S Y S T E M S

12

Compact TI 20-pin JTAG probe for DaVinci

ADA-JET-CTI20

The Signum JTAG ADA-JET-CTI20 probe provides a physical interface between the Signum JTAGjet-

eBinder emulator and DaVinci, DM and OMAP target boards. This probe has 20-pin receptacles. The pin-to-

pin X spacing is 0.10 in., Y spacing 0.05 in. The female connector on the probe is SAMTEC RSM-110-02-S-D.

This is a low votage probe operating in the 1.8 – 3.3V (± 10%) range. Figure 30 shows the probe’s pinout.

FIGURE 29 The ADA-JET-CTI20 probe for the

Signum JTAGjet-eBinder emulator.

FIGURE 30 The cTI20 pinout of the ADA-JET-

CTI20 probe. Top view.

FIGURE 31 Dimensions of the 20-pin CTI20

probe. Top view. A = 27.0 mm (1.06 in.) B = 17.8

mm (0.70 in.).

FIGURE 32 Dimensions of the 20-pin CTI20 probe.

Side view. C = 23.0 mm (.91 in.), D = 12.5 mm (0.49

in.), E = 6.4 mm (0.25 in.).

The 4-position DIP switch on the CTI20 probe allows you to convert the EMU0 or EMU1 to a CPU reset line (Figure

33

).

Pin 1

Cable to Emulator