OverPower inverter output supports longer duration overloads to 150% for 1-60 minutes under ideal battery and temperature conditions.

3-stage, selectable wet/dry cell battery charger (30-amp high/7.5-amp low)

3-position operating mode switch supports "AUTO" mode to enable automatic transfer between DC and AC modes, CHARGE-ONLY to maintain a full

battery charge when AC is present without auto transfer and SYSTEM OFF settings

Set of six front panel LEDs display AC/DC operational modes, overload status, DC voltage level, shutdown status and system fault status

Set of 4 configuration dipswitches support wet/gel battery charging profiles, adjustable 259/264V high voltage auto transfer during overvoltages and

selectable 144/163/182/201V AC low voltage auto transfer during brownouts

Set of 4 additional configuration dip switches support 4 levels of charger limiting relative to output load size

Resettable 10A charger AC input breaker and resettable 15A AC output breaker and automatic 2 speed cooling fan protect the inverter from load and

temperature related failures

Automatic overload and thermal shutoff safely turns off inverter as excessive loads or overheating conditions develop

Front panel remote control connector enables remote off/on switching (requires APSRM4 switch accessory)

Specifications

OUTPUT

Frequency Compatibility

50 Hz

Output Receptacles

Hardwire

Output (Watts)

3600

Continuous Output Capacity (Watts)

3600

Peak Output Capacity (Watts)

7200

Output Nominal Voltage

230V

Output Voltage Regulation

LINE POWER (AC): Maintains 230V nominal sine wave output from line power source. INVERTER POWER (AC):

Maintains PWM sine wave output voltage of 230 VAC (+/-5%).

Output Frequency Regulation

50 Hz (+/- 0.3 Hz)

Overload Protection

Includes 12A input breaker dedicated to the charging system and 20A output breaker for AC output loads.

Pure Sine Wave Output

No

INPUT

Nominal Input Voltage(s) Supported

230V AC

Recommended Electrical Service

DC INPUT: Requires 36VDC input source capable of delivering 114A for the required duration (when used at full

continuous capacity - DC requirements increase during OverPower and DoubleBoost operation). For automotive

applications, professional hardwire installation with 300A minimum battery system fusing is recommended.

Maximum Input Amps / Watts

DC INPUT: Full continuous load - 114A at 36VDC. AC INPUT: 26 amps at 230VAC with full inverter and charger

load (10.4A max charger-only / combined input load to support charger and AC output is automatically controllable

to 66%-33%-0% based on AC output loading using the charger limiting set points - see manual for setting

instructions)

Input Connection Type

DC INPUT: Set of DC bolt-down terminals. AC INPUT: Hardwire via built in junction box with cover plate

Voltage Compatibility (VAC)

230

Voltage Compatibility (VDC)

36

2 / 4