© 1996 Microchip Technology Inc.

DS21127B-page 5

24LCS21

3.0

BI-DIRECTIONAL MODE

The 24LCS21 can be switched into the bi-directional

Mode (Figure 3-1) by applying a valid high to low

transition on the bi-directional Mode Clock (SCL).

When the device has been switched into the bi-direc-

tional Mode, the VCLK input is disregarded, with the

exception that a logic high level is required to enable

write capability. This mode supports a two-wire bi-direc-

™). In this proto-

col, a device that sends data on the bus is defined to be

the transmitter, and a device that receives data from the

bus is defined to be the receiver. The bus must be con-

trolled by a master device that generates the bi-direc-

tional Mode Clock (SCL), controls access to the bus

and generates the START and STOP conditions, while

the 24LCS21 acts as the slave. Both master and slave

can operate as transmitter or receiver, but the master

device determines which mode is activated.

In this mode, the 24LCS21 only responds to commands

for device 1010 000X.

3.1 Bi-directional Mode Bus Characteristics

The following bus protocol has been defined:

• Data transfer may be initiated only when the bus is

not busy.

• During data transfer, the data line must remain

stable whenever the clock line is HIGH. Changes

in the data line while the clock line is HIGH will be

interpreted as a START or STOP condition.

Accordingly, the following bus conditions have been

defined (Figure 3-2).

3.1.1

BUS NOT BUSY (A)

Both data and clock lines remain HIGH.

3.1.2

START DATA TRANSFER (B)

A HIGH to LOW transition of the SDA line while the

clock (SCL) is HIGH determines a START condition. All

commands must be preceded by a START condition.

3.1.3

STOP DATA TRANSFER (C)

A LOW to HIGH transition of the SDA line while the

clock (SCL) is HIGH determines a STOP condition. All

operations must be ended with a STOP condition.

FIGURE 3-1: MODE TRANSITION

FIGURE 3-2: DATA TRANSFER SEQUENCE ON THE SERIAL BUS

SCL

SDA

VCLK

Bi-directional Mode

Transmit Only Mode

(A)

(B)

(D)

(D)

(A)

(C)

START

CONDITION

ADDRESS OR

ACKNOWLEDGE

VALID

DATA

ALLOWED

TO CHANGE

STOP

CONDITION

SCL

SDA