MAC7101CVF datasheet(24/48 Pages) MOTOROLA

24 / 48 page

MAC7100 Microcontroller Family Hardware Specifications

MOTOROLA

PRELIMINARY—SUBJECT TO CHANGE WITHOUT NOTICE

Electrical Characteristics

3.10.1.1 Source Resistance

Due to the input pin leakage current as specified in Table 15 in conjunction with the source resistance there

will be a voltage drop from the signal source to the ATD input. The maximum specified source resistance RS,

results in an error of less than 1/2 LSB (2.5 mV) at the maximum leakage current. If the device or operating

conditions are less than the worst case, or leakage-induced errors are acceptable, larger values of source

resistance are allowed.

3.10.1.2 Source Capacitance

When sampling, an additional internal capacitor is switched to the input. This can cause a voltage drop due

to charge sharing with the external capacitance and the pin capacitance. For a maximum sampling error of

the input voltage

≤ 1 LSB, then the external filter capacitor must be calculated as, Cf ≥ 1024 × (CINS – CINN).

3.10.1.3 Current Injection

There are two cases to consider:

1. A current is injected into the channel being converted. The channel being stressed has conversion

values of 0x3FF (0xFF in 8-bit mode) for analog inputs greater than VRH and 0x000 for values less

than VRL unless the current is higher than specified as disruptive condition.

2. Current is injected into pins in the neighborhood of the channel being converted. A portion of this

current is picked up by the channel (coupling ratio K), This additional current impacts the

accuracy of the conversion depending on the source resistance. The additional input voltage error

on the converted channel can be calculated as VERR =K × RS × IINJ, with IINJ being the sum of the

currents injected into the two pins adjacent to the converted channel.

Table 26. ATD Electrical Characteristics

Conditions are shown in Table 6 unless otherwise noted

Num C

Rating

Symbol

Min

Typ

Max

Unit

C Max input Source Resistance

——

Ω

T Total Input Capacitance

Non Sampling

Sampling

CINN

CINS

—

C Disruptive Analog Input Current

INA

–2.5

—

2.5

C Coupling Ratio positive current injection

——

TBD

A/A

C Coupling Ratio negative current injection

——

TBD

A/A

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

MAC7101CVF Datasheet(PDF) 24 Page - Motorola, Inc

MAC7101CVF Datasheet(HTML) 24 Page - Motorola, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

Datasheet Download

Link URL