DS1100SLPE Data Sheet

Control and Status Signals

Output Signals

ACOK

Signal used to indicate the presence of AC input to the power supply. A logic level HIGH will indicate that the AC input to the power supply is within the operating

range while a logic level LOW will indicate that AC has been lost.

This is an open collector/drain output. This pin is pulled high by a 10 kohm resistor connected to 3.3 V inside the power supply. It is recommended that this pin be

onnected to a 100 pF decoupling capacitor and pulled down by a 100 kohm resistor.

MIN

MAX

V

IL

Input logic level LOW

0.6 V

V

IH

Input logic level HIGH

2.0 V

3.6 V

I

SOURCE

Current that may be sourced by this pin

3.3 mA

I

SINK

Current that may be sunk by this pin at low state

0.7 mA

PWR_GOOD / PWOK

Signal used to indicate that main output voltage is within regulation range. The PWR_GOOD signal will be driven HIGH when the output voltage is valid and will be

driven LOW when the output falls below the under-voltage threshold.

This signal also gives an advance warning when there is an impending power loss due to loss of AC input or system shutdown request. More details in the Timing

Section.

This is an open collector/drain output. This pin is pulled high by a 10 kohm resistor connected to 3.3 V inside the power supply. It is recommended that this pin be

connected to a 100 pF decoupling capacitor and pulled down by a 100 kohm resistor.

MIN

MAX

V

IL

Input logic level LOW

0.8 V

V

IH

Input logic level HIGH

2.0 V

3.6 V

I

SOURCE

Current that may be sourced by this pin

3.3 mA

I

SINK

Current that may be sunk by this pin at low state

0.7 mA

Output Signals

PS_PRESENT

Signal used to indicate to the system that a power supply is inserted in the power bay. This pin is shorted to the standby return in the power supply. Recommended

pull-up resistor to VSB is 5.1 kohms. A 100 pF decoupling capacitor is also recommended.

PS_INTERRUPT

Active low signal used by the power supply to indicate to the system that a change in power supply status has occurred. This event can be triggered by faults such

as OVP, OCP, OTP, and fan fault. This signal can be cleared by a CLEAR_FAULT command. Recommended pull-up resistor to VSB is 5.1 kohms. A 100 pF

decoupling capacitor is also recommended.

MIN

MAX

V

IL

Input logic level LOW

0.8 V

V

IH

Input logic level HIGH

2.0 V

3.6 V

I

SOURCE

Current that may be sourced by this pin

4 mA

I

SINK

Current that may be sunk by this pin at low state

4 mA