M30LW128D datasheet(21/57 Pages) STMICROELECTRONICS

21 / 57 page

21/57

M30LW128D

Table 6. Configuration Codes

Note: 1. DQ2-DQ7 are reserved

2. When STS pin is pulsing it remains Low for a typical time of 250ns.

Table 7. Read Electronic Signature

Note: 1. SBA is the Start Base Address of each block, PRD is Protection Register Data.

2. Base Address, refer to Figure 8 and Tables 8 and 9 for more information. A23 must be Low to address the customer’s Protection

3. A0 is not used in Read Electronic Signature in either x8 or x16 mode. The data is always presented on the lower byte in x16 m ode.

Configuration

Code

DQ1

DQ2

Mode

STS Pin

Description

00h

Ready/Busy

VOL during P/E

operations

Hi-Z when the

memory is ready

The STS pin is Low during Program and

Erase operations and high impedance when

the memory is ready for any Read, Program

or Erase operation.

01h

Pulse on Erase

complete

Pulse Low then High

when operation

completed(2)

Supplies a system interrupt pulse at the end

of a Block Erase operation.

02h

Pulse on

Program

complete

Supplies a system interrupt pulse at the end

of a Program operation.

03h

Pulse on Erase

or Program

complete

Supplies a system interrupt pulse at the end

of a Block Erase or Program operation.

Code

Bus Width

Address (A23-A1)(3)

Data (DQ15-DQ0)

Manufacturer Code

000000h

20h

x16

0020h

Device Code

000001h

17h

x16

8817h

Block Protection Status

SBA(1)+02h

00h (Block Unprotected)

01h (Block Protected)

x16

0000h (Block Unprotected)

0001h (Block Protected)

Protection Register

x8, x16

000080h(2)

PRD(1)

M30LW128D Datasheet(PDF) 21 Page - STMicroelectronics

M30LW128D Datasheet(HTML) 21 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57

Datasheet Download

Link URL