This document is proprietary. Any dispatch or disclosure of content is authorized only after written authorization by PULS GmbH.

All parameters are specified at 400V, 2.5A, 230Vac, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

Specification: SP-PAS395 Rev: 3.1

Date: 2013/01/19

10-14

11

EMC

EMC Immunity

Generic standards: EN 61000-6-1 and EN 61000-6-2

Electrostatic discharge

EN 61000-4-2

Contact discharge

Air discharge

8kV

15kV

Criterion A

Criterion A

Electromagnetic RF field

EN 61000-4-3

80MHz-2.7GHz

20V/m

Criterion A

Fast transients (Burst)

EN 61000-4-4

Input lines

Output lines

Signal lines

4kV

4kV

2kV

Criterion A

Criterion A

Criterion A

Surge voltage on input

EN 61000-4-5

EN 61400-24

L  N

L  N

2kV

LPZ 2

Criterion A

EN 61000-4-5

EN 61400-24

L  PE

L  PE

4kV

LPZ 2

Criterion A

Surge voltage on output

EN 61000-4-5

EN 61400-24

+  -

+  -

1kV

LPZ 2

Criterion A

EN 61000-4-5

EN 61400-24

+ / -  PE

+ / -  PE

4kV

LPZ 2

Criterion A

Surge voltage on signals

EN 61000-4-5

EN 61400-24

signal  PE

signal  PE

1kV

LPZ 2

Criterion A

Conducted disturbance

EN 61000-4-6

0.15-80MHz

20V

Criterion A

Mains voltage dips

EN 61000-4-11

0% of 220Vac (=0V)

40% of 220Vac (=88V)

70% of 220Vac (=154V)

20ms

200ms

500ms

Criterion A

Criterion C *)

Criterion A

Voltage interruptions

EN 61000-4-11

0% of 220Vac (=0V)

5000ms

Criterion C

Powerful transients

VDE 0160

over entire load range

750V, 1.3ms

see note M

Criterions:

A:

Power supply shows normal operation behavior within the defined limits.

C:

Temporary loss of function is possible. Power supply may shut-down and restarts by itself. No damage or hazards for the

power supply will occur.

*) signal status and LED will remain appropriate (= Criterion A)

Note M: The protection circuit switches off the converter for approx. 2 seconds, which is not considered to be a problem for the

charging process.

EMC Emission

Generic standards: EN 61000-6-4

Conducted emission

EN 55011, EN 55022, FCC Part 15, CISPR 11,

CISPR 22

Input lines:

Class A

Signal lines:

Class A

Radiated emission

EN 55011, EN 55022

Class A

Harmonic input current

EN 61000-3-2

Class A fulfilled (active PFC)

Voltage fluctuations, flicker EN 61000-3-3

fulfilled

*)

This device complies with FCC Part 15 rules.

Operation is subjected to following two conditions: (1) this device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause undesired operation.

*)

Tested with constant current loads, non pulsing