XRT83SL34 datasheet(65/80 Pages) EXAR

65 / 80 page

XRT83SL34

QUAD T1/E1/J1 SH TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR

PRELIMINARY

REV. P1.0.8

CLOCK SELECT REGISTER

The input clock source is used to generate all the necessary clock references internally to the LIU. The

microprocessor timing is derived from a PLL output which is chosen by programming the Clock Select Bits and

the Master Clock Rate in register 0x41h. Therefore, if the clock selection bits or the MCLRATE bit are being

programmed, the frequency of the PLL output will be adjusted accordingly.

During this adjustment, it is

important to "Not" write to any other bit location within the same register while selecting the input/output clock

frequency. For best results, when bits D[6:3] are being changed, the other bits D[7] and D[2:0] as shown in

Figure 23. should retain their previous values.

FIGURE 23. REGISTER 0X81H SUB REGISTERS

Programming Examples:

Example 1: Changing bits D[6:3]

If bits D[6:3] are the only values within the register that will change in a WRITE process, the microprocessor

only needs to initiate ONE write operation.

Example 2: Changing bits D[7] and D[2:0]

If bits D[7] and D[2:0] are the only values within the register that will change in a WRITE process, the

microprocessor only needs to initiate ONE write operation.

Example 3: Changing bits within D[6:3] and the other bits

In this scenario, one must initiate TWO write operations such that bits D[6:3] and the other bits do not change

within ONE write cycle. It is recommended that bits D[6:0] and the other bits be treated as two independent

sub-registers. One can either change the clock selection bits and then change bits D[7] and D[2:0] on the

SECOND write, or vice-versa. No order or sequence is necessary.

Clock Selection Bits

ExLOS, ICT

E1arben

XRT83SL34 Datasheet(PDF) 65 Page - Exar Corporation