SH7041A datasheet(733/923 Pages) RENESAS

733 / 923 page

695

22.5.3

Erase Block Register 1 (EBR1)

EBR1 is an 8-bit register that specifies the flash memory erase area block by block. EBR1 is

initialized to H'00 by a power-on reset and standby mode, when a high level is input to the FWP

pin, and when a low level is input to the FWP pin and the SWE bit in FLMCR1 is not set. When a

bit in EBR1 is set to 1, the corresponding block can be erased. Other blocks are erase-protected.

Only one of the bits of EBR1 and EBR2 combined can be set. Do not set more than one bit. If

more than one bit is set, writes to bits ESU1, ESU2, E1, and E2 will be invalid. When on-chip

flash memory is disabled, a read will return H'00, and writes are invalid.

The flash memory block configuration is shown in table 22.4.

Bit:

—

EB3

EB2

EB1

EB0

Initial value:

R/W:

R/W

22.5.4

Erase Block Register 2 (EBR2)

EBR2 is an 8-bit register that specifies the flash memory erase area block by block. EBR2 is

initialized to H'00 by a power-on reset and standby mode, when a high level is input to the FWP

pin, and when a low level is input to the FWP pin and the SWE bit in FLMCR1 is not set. When a

bit in EBR2 is set to 1, the corresponding block can be erased. Other blocks are erase-protected.

When on-chip flash memory is disabled, a read will return H'00, and writes are invalid.

The flash memory block configuration is shown in table 22.4.

Bit:

EB11

EB10

EB9

EB8

EB7

EB6

EB5

EB4

Initial value:

R/W:

R/W

SH7041A Datasheet(PDF) 733 Page - Renesas Technology Corp