AS89010 datasheet(39/42 Pages) AMSCO

39 / 42 page

ams.com

db12348e_V3.11_preliminary_2017-07-06

Page 38 of 41

AS89010

V3.11

9 NOTES FOR PCB LAYOUT

The connections to the inputs IN0…IN3 of the AS89010 have to be protected against any

kind of electromagnetic coupling and have to be guarded with VRT potential to avoid leak-

age currents. Without guarding layers at the inputs the isolation resistance of the PCB

gives leakage currents with equivalent values like the sensor currents!

The analog supply for AS89010 must be placed as close as possible to the converter. The connection

between the analog and digital ground should be beneath (LP level) and/or near the AS89010.

Digital signals and circuit lines with high current loads must not be used directly beneath and next to the

photodiode sensor as well as the AS89010.

The AS89010 converter operates internally with minimal currents (pAmps). Therefore, protection measures

need to be performed to shield the ASIC against EMC stress or external interferences.

The connections between the photodiode sensor (anode and de) and the AS89010 should be as short as

possible (<10 mm) and without interlayer connections.

Photodiode Sensor, AS89010 and its REXT should be placed on the same PCB side. The signal VRT (common

cathode or common anode) should have the same cross-section as the four sensor connectors.

Around signal lines a conductor connected with VRT should be created. One level below the signals a VRT

potential area should be created that extends only to the analog inputs and the signal lines.

AS89010 Datasheet(PDF) 39 Page - ams AG