IN100-Q1-R-RC1F datasheet(19/49 Pages) ETC

19 / 49 page

18 / 47

www.inplay-tech.com

N1EDOC-DS-IN100-EN-V1.3

Condition

index

Condition

Description

Sensor 0

level too high

An external sensor connected to an MGPIO pin measured

through the internal ADC is higher than a threshold provided

in region 1 of the eFuse memory or SRAM. Sensor 0 can be

specified as one of the GPIO inputs using control registers*.

Sensor 0

level too low

An external sensor connected to an MGPIO pin measured

through the internal ADC is lower than a threshold provided in

region 1 of the eFuse memory or SRAM.

Sensor 1 level

too high

An external sensor connected to an MGPIO pin measured

through the internal ADC is higher than a threshold provided

in region 1 of the eFuse memory. Sensor 1 can be specified as

one of the MGPIO inputs using control registers*.

Sensor 1 level

too low

An external sensor connected to an MGPIO pin measured

through the internal ADC is lower than a threshold provided in

region 1 of the eFuse memory or SRAM.

GPIO wakeup

Any GPIO-triggered wake up. The wake-up condition can be

specified through control registers*.

Note: the control register content can be generated by the NanoBeacon Config PC GUI tool

provided by InPlay.

3.5.3. Advertising data source

Each advertising packet may contain a sequence of up to 15 fields. Field 0 may contain specified

header and/or address information, while all other 14 fields may contain one of the following types

of data.

Table 5 : Advertising data source

Data type

Description

Predefined Data

The data (and their length) is defined in the eFuse memory directly

and may not be changed later.

Timer value

Values from AON timers, or the converted SEC_CNT value in 0.1

second or 1 second resolution.

Random number

A random number created through the LFSR (see chapter 4.6). The

random value might also be used in EAX encryption as the salt.

Internal

Temperature/Battery

voltage measurement

Internal ADC measurements of the device temperature or the VCC

voltage value.

External analog sensor

measurement

Internal ADC measurement of a signal from the external analog

sensor through MGPIO 4 to 7.

IN100-Q1-R-RC1F Datasheet(PDF) 19 Page - List of Unclassifed Manufacturers

IN100-Q1-R-RC1F Datasheet(HTML) 19 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

Datasheet Download

Link URL