74VHCT240AFT,74VHCT244AFT

4

9.

9.

9.

9. Absolute Maximum Ratings (Note)

Absolute Maximum Ratings (Note)

Absolute Maximum Ratings (Note)

Absolute Maximum Ratings (Note)

Characteristics

Supply voltage

Input voltage

Output voltage

Input diode current

Output diode current

Output current

VCC/ground current

Power dissipation

Storage temperature

Symbol

VCC

VIN

VOUT

IIK

IOK

IOUT

ICC

PD

Tstg

Note

(Note 1)

(Note 2)

(Note 3)

(Note 4)

Rating

-0.5 to 7.0

-0.5 to 7.0

-0.5 to 7.0

-0.5 to VCC + 0.5

-20

±20

±25

±75

180

-65 to 150

Unit

V

V

V

mA

mA

mA

mA

mW



Note:

Exceeding any of the absolute maximum ratings, even briefly, lead to deterioration in IC performance or even

destruction.

Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the

significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even

if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum

ratings and the operating ranges.

Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook

(“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test report

and estimated failure rate, etc).

Note 1: Output in off-state.

Note 2: High (H) or Low (L) state. IOUT absolute maximum rating must be observed.

Note 3: VOUT < GND, VOUT > VCC

Note 4: 180 mW in the range of Ta = -40 to 85 . From Ta = 85 to 125  a derating factor of -3.25 mW/ shall be

applied until 50 mW.

10.

10.

10.

10. Operating Ranges (Note)

Operating Ranges (Note)

Operating Ranges (Note)

Operating Ranges (Note)

Characteristics

Supply voltage

Input voltage

Output voltage

Operating temperature

Input rise and fall times

Symbol

VCC

VIN

VOUT

Topr

dt/dv

Note

(Note 1)

(Note 2)

Rating

4.5 to 5.5

0 to 5.5

0 to 5.5

0 to VCC

-40 to 125

0 to 20

Unit

V

V

V



ns/V

Note:

The operating ranges must be maintained to ensure the normal operation of the device.

Unused inputs must be tied to either VCC or GND.

Note 1: Output in OFF state.

Note 2: High (H) or Low (L) state.

2017-02-23

Rev.4.0

©2017 Toshiba Corporation