LIS202DL datasheet(17/36 Pages) STMICROELECTRONICS

17 / 36 page

LIS202DL

Digital interfaces

17/36

The SPI Write command is performed with 16 clock pulses. Multiple byte write command is

performed adding blocks of 8 clock pulses at the previous one.

bit 0: WRITE bit. The value is 0.

bit 1: MS bit. When 0 do not increment address, when 1 increment address in multiple

writing.

bit 2 -7: address AD(5:0). This is the address field of the indexed register.

bit 8-15: data DI(7:0) (write mode). This is the data that will be written inside the device

(MSb first).

bit 16-... : data DI(...-8). Further data in multiple byte writing.

Figure 8.

Multiple bytes SPI write protocol (2 bytes example)

5.2.3

SPI read in 3-wires mode

3-wires mode is entered by setting to 1 bit SIM (SPI Serial Interface Mode selection) in

CTRL_REG2.

Figure 9.

SPI read protocoin 3-wires model

The SPI Read command is performed with 16 clock pulses:

bit 0: READ bit. The value is 1.

bit 1: MS bit. When 0 do not increment address, when 1 increment address in multiple

reading.

bit 2-7: address AD(5:0). This is the address field of the indexed register.

bit 8-15: data DO(7:0) (read mode). This is the data that will be read from the device (MSb

first).

Multiple read command is also available in 3-wires mode.

SPC

SDI

AD5 AD4 AD3 AD2 AD1 AD0

DI7 DI6 DI5 DI4 DI3 DI2 DI1 DI0 DI15 DI14 DI13 DI12 DI11 DI10 DI9 DI8

SPC

SDI/O

DO7 DO6 DO5 DO4 DO3 DO2 DO1 DO0

AD5 AD4 AD3 AD2 AD1 AD0

LIS202DL Datasheet(PDF) 17 Page - STMicroelectronics