TPS54386PWPR datasheet(16/52 Pages) TI

16 / 52 page

www.ti.com

Output Voltage Regulation

REF

OUT

- VREF

R2=R1´

(2)

PVDD2

BOOT2

SW2

PVDD1

BOOT1

SW1

GND

TPS5438x

SEQ

ILIM2

FB2

EN1

EN2

FB1

OUTPUT1

UDG-07011

TPS54383,, TPS54386

SLUS774B – AUGUST 2007 – REVISED OCTOBER 2007

to support the desired regulation voltage by the time Soft Start has completed, then

the output UV circuit may trip and cause a hiccup in the output voltage. In this case,

use a timed delay startup from the ENx pin to delay the startup of the output until the

PVDDx voltage has the capability of supporting the desired regulation voltage. See

Operating Near Maximum Duty Cycle and Maximum Output Capacitance for related

information.

Each output has a dedicated feedback loop comprised of a voltage setting divider, an error amplifier, a pulse

width modulator, and a switching MOSFET. The regulation output voltage is determined by a resistor divider

connecting the output node, the FBx pin, and GND (see Figure 21). Assuming the value of the upper voltage

setting divider is known, the value of the lower divider resistor for a desired output voltage is calculated by

Equation 2.

where

• V

REF is the internal 0.8-V reference voltage

Figure 21. Feedback Network for Channel 1

DESIGN HINT

There is a leakage current of up to 12

µA out of the SW pin when a single output of

the TPS5438x is disabled. Keeping the series impedance of R1 + R2 less than 50 k

Ω

prevents the output from floating above the referece voltage while the controller output

is in the OFF state.

Submit Documentation Feedback

Product Folder Link(s): TPS54383 TPS54386

TPS54386PWPR Datasheet(PDF) 16 Page - Texas Instruments

TPS54386PWPR Datasheet(HTML) 16 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

Datasheet Download

Link URL