LM3535

D1A D2A D3A D4A

D53

I

2C

Control

Signals

D1B/

INT

SDIO

1µF

1µF

1µF

1µF

GND

D62

C1+

C1-

C2+

C2-

SCL

D1C/

ALS

HWEN

GROUP A

GROUP B

GROUP C

PWM

O

R

VIO

VIN

VOUT

Product

Folder

Order

Now

Technical

Documents

Tools &

Software

Support &

Community

An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,

intellectual property matters and other important disclaimers. PRODUCTION DATA.

LM3535

SNVS598B – AUGUST 2010 – REVISED MARCH 2018

LM3535 Multi-Display LED Driver With Ambient Light Sensing and Dynamic

Backlight Control Compatibility

1

1 Features

1

•

Drives Up to 8 LEDs Each With Up to 25 mA of

Diode Current

•

External PWM Input for Dynamic Backlight Control

•

Multi-Zone Ambient Light Sensing (ALS)

•

ALS Interrupt Reporting

•

Independent On/Off Control for All Current Sinks

•

128 Exponential Dimming Steps With 600:1

Dimming Ratio for Group A (Up to 6 LEDs)

•

8 Linear Dimming States for Groups B (Up to 3

LEDs) and D1C (1 LED)

•

Programmable Auto-Dimming Function

•

Up to 90% Efficiency

•

0.55% Accurate Current Matching

•

Wide Input Voltage Range (2.7 V to 5.5 V)

•

Active High Hardware Enable

•

Total Solution Size < 16 mm2

•

Low Profile 20-Pin DSBGA Package

2 Applications

•

Smart-Phone LED Backlighting

•

Large Format LCD Backlighting

•

General LED Lighting

3 Description

The LM3535 device is a highly integrated LED driver

capable of driving 8 LEDs in parallel for large display

applications.

Independent

LED

control

allows

selection of a subset of the 6 main display LEDs for

partial-illumination applications. In addition to the

main bank of 6, the LM3535 is capable of driving an

additional 2 independently controlled LEDs to support

Indicator applications.

The LED driver current sinks are split into three

independently controlled groups. The primary group

can be configured to drive up to six LEDs for use in

the main phone display. Groups B and C are

provided for driving secondary displays, keypads and

indicator LEDs. All of the LED current sources can be

independently turned on and off providing flexibility to

address different application requirements.

The

LM3535

provides

multi-zone

ambient

light

sensing

allowing

autonomous

backlight

intensity

control in the event of changing ambient light

conditions. A PWM input is also provided to give the

user the means to adjust the backlight intensity

dynamically based upon the content of the display.

The LM3535 provides excellent efficiency without the

use of an inductor by operating the charge pump in a

gain of 3/2 or in pass mode. The proper gain for

maintaining current regulation is chosen, based on

LED forward voltage, so that efficiency is maximized

over the input voltage range.

The LM3535 is available in a tiny 20-pin, 0.4-mm

pitch, thin DSBGA package.

Device Information(1)

PART NUMBER

PACKAGE

BODY SIZE (MAX)

LM3535

DSBGA (20)

2.045 mm × 1.64 mm

(1) For all available packages, see the orderable addendum at

the end of the data sheet.

Typical Application