DLPC3430 datasheet(43/58 Pages) TI2

43 / 58 page

Current (mA)

100

200

300

400

500

600

700

0.1

0.2

0.3

0.4

0.5

0.6

0.7

0.8

0.9

D001

DLPA2000

www.ti.com

DLPS043B – JUNE 2014 – REVISED FEBRUARY 2018

Product Folder Links: DLPA2000

Submit Documentation Feedback

Typical Projector Application (continued)

8.2.3 Application Curve

As the LED currents that are driven time-sequentially through the red, green, and blue LEDs are increased, the

brightness of the projector increases. This increase is somewhat non-linear, and the curve for typical white

screen lumens changes with LED currents is as shown in Figure 43. For the LED currents shown, it is assumed

that the same current amplitude is applied to the red, green, and blue LEDs.

SPACE

Figure 43. Luminance vs Current

8.3 Typical Mobile Sensing Application

A typical embedded system application using the DLPC150 controller and the DLPC2010NIR is shown in

Figure 44. In this configuration, the DLPC150 controller supports a 24-bit parallel RGB input, typical of LCD

interfaces, from an external source or processor. The DLPC150 controller processes the digital input image and

converts the data into the format needed by the DLP2010NIR. The DLP2010NIR steers light by setting specific

micromirrors to the on position, directing light to the detector, while unwanted micromirrors are set to the off

position, directing light away from the detector. The microprocessor sends binary images to the DLP2010NIR to

steer specific wavelengths of light into the detector. The microprocessor uses an analog-to-digital converter to

sample the signal received by the detector into a digital value. By sequentially selecting different wavelengths of

light and capturing the values at the detector, the microprocessor can then plot a spectral response to the light.

DLPC3430 Datasheet(PDF) 43 Page - Texas Instruments