LAN9312 datasheet(25/458 Pages) SMSC

25 / 458 page

High Performance Two Port 10/100 Managed Ethernet Switch with 32-Bit Non-PCI CPU Interface

Datasheet

SMSC LAN9312

Revision 1.2 (04-08-08)

DATASHEET

2.2.9

GPIO/LED Controller

The LAN9312 provides 12 configurable general-purpose input/output pins which are controlled via this

module. These pins can be individually configured via the GPIO/LED CSRs to function as inputs, push-

pull outputs, or open drain outputs and each is capable of interrupt generation with configurable

polarity. Two of the GPIO pins (GPIO[9:8]) can be used for IEEE 1588 timestamp functions, allowing

GPIO driven 1588 time clock capture when configured as an input, or GPIO output generation based

on an IEEE 1588 clock target compare event.

In addition, 8 of the GPIO pins can be alternatively configured as LED outputs. These pins, GPIO[7:0]

(nP1LED[3:0] and nP2LED[3:0]), may be enabled to drive Ethernet status LEDs for external indication

of various attributes of the switch ports.

2.3

System Configuration

In a typical application, the LAN9312 Host Bus Interface (HBI) is connected to the host

microprocessor/microcontroller via the asynchronous 32-bit interface, allowing access to the LAN9312

system configuration and status registers. The LAN9312 utilizes the internal Host MAC to provide a

network path for the host CPU. The LAN9312 may share the host bus with additional system memory

and/or peripherals. For more information on the HBI, refer to Chapter 8, "Host Bus Interface (HBI)," on

page 99.

The 2 Ethernet ports of the LAN9312 must be connected to Auto-MDIX style magnetics for proper

operation on the Ethernet network. Refer to the SMSC Application Note 8.13 “Suggested Magnetics”

for further details.

The LAN9312 also supports optional EEPROM and GPIOs/LEDs. When an EEPROM is connected,

the EEPROM loader can be used to load the initial device configuration from the external EEPROM

via the I2C/Microwire interface.

A system configuration diagram of the LAN9312 in a typical embedded environment can be seen in

Figure 2.2.

Figure 2.2 System Block Diagram

Magnetics

To Ethernet

External

25MHz Crystal

Microprocessor/

Microcontroller

GPIOs/LEDs

(optional)

System

Memory

System

Peripherals

EEPROM

(optional)

LAN9312

2C/Microwire

LAN9312 Datasheet(PDF) 25 Page - SMSC Corporation

LAN9312 Datasheet(HTML) 25 Page - SMSC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL