NXP Semiconductors

UM11144

FRDM-HB2002ESEVM evaluation board

UM11144

All information provided in this document is subject to legal disclaimers.

© NXP B.V. 2018. All rights reserved.

User guide

Rev. 1.0 — 13 September 2018

3 / 27

2.4 Software

Installing software is necessary to work with this evaluation board. All listed software

is available on the evaluation board's information page at http://www.nxp.com/FRDM-

HB2002ESEVM.

• SPI Generator (SPIGen) software, version 7.1.8 or later, a Graphical User Interface

(GUI)

Note: Software must be installed in a specific order. See Configuring the hardware.

3 Getting to know the hardware

The NXP analog product development boards provide an easy-to-use platform for

evaluating NXP products. The boards support a range of analog, mixed-signal and

power solutions. They incorporate monolithic integrated circuits and system-in-package

devices that use proven high-volume technology. NXP products offer longer battery life, a

smaller form factor, reduced component counts, lower cost and improved performance in

powering state-of-the-art systems.

3.1 Kit overview

3.1.1 FRDM-HB2002ESEVM features

The FRDM-HB2002ESEVM board evaluates the NXP part MC33HB2002, including all

functions. The board features the following:

• Built-in reverse battery protection

• Test points that allow signal probing

• Built-in voltage regulator to supply logic level circuitry

• Current feedback network for real-time load current monitoring by MCU ADC

• LEDs to indicate the supply status and the direction of the motor

• Low ESR capacitor to reduce ripple in the power supply

• TVS protection diode to handle system level transients