H8SLASH3028F datasheet(658/923 Pages) RENESAS

658 / 923 page

Rev. 2.00, 09/03, page 628 of 890

19.2.2

External Clock Input

Circuit Configuration: An external clock signal can be input as shown in the examples in figure

19.5. If the XTAL pin is left open, the stray capacitance should not exceed 10 pF. If the stray

capacitance at the XTAL pin exceeds 10 pF in configuration a, use the connection shown in

configuration b instead, and hold the external clock high in standby mode.

EXTAL

XTAL

EXTAL

XTAL

External clock input

Open

External clock input

a. XTAL pin left open

b. Complementary clock input at XTAL pin

Figure 19.5 External Clock Input (Examples)

External Clock: The external clock frequency should be equal to the system clock frequency when

not divided by the on-chip frequency divider. Table 19.3 shows the clock timing, figure 19.6

shows the external clock input timing, and figure 19.7 shows the external clock output settling

delay timing. When the appropriate external clock is input via the EXTAL pin, its waveform is

corrected by the on-chip oscillator and duty adjustment circuit.

When the appropriate external clock is input via the EXTAL pin, its waveform is corrected by the

on-chip oscillator and duty adjustment circuit. The resulting stable clock is output to external

devices after the external clock settling time (tDEXT) has passed after the clock input. The system

must remain reset with the reset signal low during tDEXT, while the clock output is unstable.

H8/3028F Datasheet(PDF) 658 Page - Renesas Technology Corp