| Electronic Components Datasheet Search |
|
PCIMX515CJM6C Datasheet(PDF) 128 Page - Freescale Semiconductor, Inc |
|
|
|||||||||||||||||||||||||||||
PCIMX515CJM6C Datasheet(HTML) 128 Page - Freescale Semiconductor, Inc |
|
128 / 184 page ![]() i.MX51 Applications Processors for Consumer and Industrial Products, Rev. 1 128 Freescale Semiconductor Preliminary—Subject to Change Without Notice Electrical Characteristics 3.7.16 UART Table 93 shows the UART I/O configuration based on which mode is enabled. 3.7.17 USBOH3 Parameters This section describes the electrical parameters of the USB OTG port and USB HOST ports. For on-chip USB PHY parameters see Section 3.7.19, “USB PHY Parameters.” 3.7.17.1 USB Serial Interface In order to support four serial different interfaces, the USB serial transceiver can be configured to operate in one of four modes: • DAT_SE0 bidirectional, 3-wire mode • DAT_SE0 unidirectional, 6-wire mode • VP_VM bidirectional, 4-wire mode • VP_VM unidirectional, 6-wire mode The USB controller does not support ULPI Serial mode. Only the legacy serial mode is supported. Table 93. UART I/O Configuration vs. Mode Port DTE Mode DCE Mode Direction Description Direction Description RTS Output RTS from DTE to DCE Input RTS from DTE to DCE CTS Input CTS from DCE to DTE Output CTS from DCE to DTE DTR Output DTR from DTE to DCE Input DTR from DTE to DCE DSR Input DSR from DCE to DTE Output DSR from DCE to DTE DCD Input DCD from DCE to DTE Output DCD from DCE to DTE RI Input RING from DCE to DTE Output RING from DCE to DTE TXD_MUX Input Serial data from DCE to DTE Output Serial data from DCE to DTE RXD_MUX Output Serial data from DTE to DCE Input Serial data from DTE to DCE Table 94. Serial Mode Signal Map for 6-pin FsLs Serial Mode Signal Maps to Direction Description tx_enable data(0) In Active high transmit enable tx_dat data(1) In Transmit differential data on D+/D– tx_se0 data(2) In Transmit single-ended zero on D+/D– int data(3) Out Active high interrupt indication Must be asserted whenever any unmasked interrupt occurs rx_dp data(4) Out Single-ended receive data from D+ rx_dm data(5) Out Single-ended receive data from D– |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |