ST10F276Z5 datasheet(205/239 Pages) STMICROELECTRONICS

205 / 239 page

ST10F276Z5

Electrical characteristics

205/239

Figure 55.

32 kHz crystal oscillator connection diagram

The given values of CA do not include the stray capacitance of the package and of the

printed circuit board: The negative resistance values are calculated assuming additional

5 pF to the values in the table. The crystal shunt capacitance (C0), the package and the

stray capacitance between XTAL3 and XTAL4 pins is globally assumed equal to 4 pF. The

external resistance between XTAL3 and XTAL4 is not necessary, since already present on

the silicon.

Warning:

Direct driving on XTAL3 pin is not supported. Always use a

32 kHz crystal oscillator.

23.8.15

External clock drive XTAL1

When Direct Drive configuration is selected during reset, it is possible to drive the CPU clock

directly from the XTAL1 pin, without particular restrictions on the maximum frequency, since

the on-chip oscillator amplifier is bypassed. The speed limit is imposed by internal logic that

targets a maximum CPU frequency of 64 MHz.

In all other clock configurations (Direct Drive with Prescaler or PLL usage) the on-chip

oscillator amplifier is not bypassed, so it determines the input clock speed limit. Then an

external clock source can be used but limited in the range of frequencies defined for the

usage of crystal and resonator (refer also to Table 97 on page 198).

External clock drive timing conditions: VDD = 5 V ±10%, VSS = 0 V, TA = –40 to +125 °C

Table 103.

Minimum values of negative resistance (module)

CA = 6 pF CA = 12 pF CA = 15 pF CA = 18 pF CA = 22 pF CA = 27 pF CA = 33 pF

32 kHz

----

150 k

Ω

120 k

Ω

90 kW

Crystal

ST10F276

ST10F276Z5 Datasheet(PDF) 205 Page - STMicroelectronics