FX829D2 datasheet(11/34 Pages) CMLMICRO

11 / 34 page

Baseband Signal Processor

FX829

D/829/4

MIC

(Bit 1)

When this bit is "1", the MIC input is enabled and the AMP1 (DEMODIN) input is

disabled.

When this bit is "0", the AMP1 (DEMODIN) input is enabled and the MIC input is

disabled.

B/W

(Bit 0)

When this bit is "1", the bandwidth of the audio path is set wide for 20kHz/25kHz

RF channel spacing.

When this bit is "0", the bandwidth of the audio path is set narrow for 12.5kHz RF

channel spacing.

CONTROL 2 Register (Hex address $11)

This register is used to control the functions of the device as described below:

CHKSUM

(Bit 7)

In the Tx mode, when this bit is "1", the checksum generator is enabled.

All

complete bytes that are transmitted after this time are used in the checksum

calculation.

When this bit goes from "1" to "0", the checksum generator will complete its

calculations on the current byte and the result will be sent as the next two bytes of

transmitted data.

In the Rx mode, the "0" to "1" transition of the CHKSUM bit is used at the start of

the next byte received at DEMODIN to manually reset the Rx checksum

calculation, see Figure 4. The calculation can also be reset automatically by a

SYNC, SYNT, or RX SYNC WORD detection - see CONTROL 3 / IRQ ENABLE

after the 2-byte sync word has been detected. The CHKSUM bit can be reset to

"0" at any time. The result of the checksum is made available in the STATUS

STATUS Register).

Note that the device is designed to work with any message length, and as a

consequence it is not aware of the position of the checksum within the incoming

data message.

It thus performs a checksum assessment after every received

byte. The controlling software should use its knowledge of the system message

length in order to determine which RXSUMF reading is valid, i.e. after the second

of the two checksum bytes has been received.

The timing of data bytes relative to the checksum bit is shown in Figures 3 and 4.

FX829D2 Datasheet(PDF) 11 Page - CML Microcircuits